Castle Creations Torque Limiter For No Prep Drag How To 

Great content bro! There isn't enough info on how to setup Castle No prep cars out there, I appreciate this a lot.

Listen up guys dre put up a banger nobody has any good info on torque limiter on the castle its actually a game changer and is like turbo on a maclan with your m17 imo 11 is perfect

Thanks for the information! I was glad to see you did this with a spectrum remote. I will be using the same and didn’t think I would be able to really tune anything.

Thanks for the information great content I'm about to take the Tekin RX8 out of my front wheel drive drag car and put the Mamba Monster X back in

Appreciate you taking the time, thanks. Any recommendations on a 7700tp and copperhead 10 in a carbon drag slash? I've managed a 2.90 at 51, but car should hit 80. I'm wondering if controller is in training mode, but can't figure how to change on tqi receiver, as it's not running the velineon ESC. I'm tracking straight, running 20t to 90t spur, but my throttle doesn't accelerate past around 3/4 trigger.

Great info bro. Nice job.

Good to know. Does it limit the torque through the entire rpm range?

When adjusting with the radio. Do the aux trim increments need to be set to a certain amount. Or just 1

Great video man thanks

I got my mamba monster last week, waiting on my 14series motor. Did u have to do big pinion small spur like castle recommends ?

If I'm using my radio to adjust the torque where should I leave the setting in the ESC? Minimum or Max?

You guys doing the points race by the college?

Could I run the test with pinion still connected and wheeels spinning

u can test with any voltage?

Thank You!

How do you set it up on the m17

awesome rc and great info brother