Setup and maiden flight of a Chimera 7 Pro V2 analog. This quad is equipped with a 2.5 W vtx and a Crossfire diversity receiver. The new GPS sensor has an outstanding performance.
Hi. Have not encountered this problem - I have collected a chimera esc 55a, 1350kv, 70c battery. So at a sharp throttle - you can see that the voltage drops critically and the picture freezes - literally. Last time I even turned it off in flight myself, as I thought I would lose control. Standard capacitor 470 is put on the input. I think it may be a mistake that I did not buy a filter on chips, and put a capacitor that came with Fc
Another big bird in the air 👊🏻 Going the analogue route there should be no stopping you now 🚀 I wonder how far the video signal will allow you to go 🚀🚀🚀🤦🏻♂️😃
Thanks Kev, I‘ll let you know 👍👍. The new M10 GPS module is phantastic !! More than 20 satellites within a minute 💪💪. Until now I was only 1 km out, without any helical on my goggles. This bird runs on BF 4.3.x and GPSrescue doesn’t work at present as reliable as I‘m used from my other quads (They run on BF 4.2). Next test flights will be with deactivated barometer. I hope for better weather and then we’ll ll see what happens … 🙏😅. Take care my friend 🍻✊.
Hey Big Boy✊ I have my girls hanging on wall and ready to shred leafs and wood ! lol I downloaded UAV BF presets tonight. Trying to clean up the wobbles and mild jello. Are them ZEE lipo"s as shitty as they say ?
Hi my friend, thanks for watching and your comment ✊. No, I‘ve totally different experiences with these Zeee lipos. Great power (120C) and on my old Chimera 7 around 7 minutes flight time with full GoPro 8 at mild cruising … Try them when you don’t want to go on long range ✊
So, I set my radio transmitter to a packet rate of 50Hz, but I keep hearing this notification popping up: "Telemetry Lost - Telemetry Recovered." Any idea what might be causing that?
„Telemetry lost and recovered“ is not critical. As far as I remember the telemetry data are sent with only 100mW power but you use more power to control your quad on long range. There is a tutorial from Joshua Bardwell where he explains this issue. Check it when you are interested in more details! Another question is: „Is 1 Watt on the radio the best choice?“ There are pilots who say that 1 Watt power provides too much interference with your video signal … That’s another issue for me to be investigated with my analog bird and maybe as well with the digital quads … So much to do my friend … 😮💨😆✊✊
Yes, I heard about it. I have 1W... I saw a video from Giant_Ant_Cowboy on that topic and I tried flying with 100 mW, but I didn't notice any difference. Maybe because the video and radio signals are not on the same frequency... I don't know... I will watch the video you recommended. Thank you!@@themoggidriver
