I am still chasing my fuel delivery issues. I have now lowered my fuel pump. It's actually looking like the stock fuel filter might be the gremlin. I think I need flood beam work lights.
I have the AGT mini skid and my machine would run fine for 30+ minutes then surge a little before stalling. Very frustrating.!! I replaced the original fuel filter with a lawn & garden fuel filter from Autozone. This resolved the problem. My mini skid runs lke a top now.!! Hope this helps. 👍🏾
@jerald307 I could have saved a lot of work starting there, but I couldn't see any debris in the filter. I was mistaken. It had crap in it. Happy to hear you did start there and all is good.
@goodwinezone2320 Start with replacing the stock fuel filter. There are insulated fuel line covers on amazon. I thought about adding one, but after all of my mods (which probably weren't needed...just the filter) I haven't had any issues.
I've finally had a chance to put a few hours (~5) on my TPM T-460 mini skid. I've gone through about 4 gallons of fresh fuel and haven't had a single fuel related issue. it's never died or bogged down other than my overworking it. fuel system is completely stock. I have noticed the hydraulic oil gets very hot! (110c) while running at full throttle for more than 30 minutes, it was ~102f outside at the time. I'm thinking about making an intake duct to direct outside air to the hydraulic cooler instead of it sucking the hot air right off the engine exhaust. does yours run hot? I've also noticed the hydraulic oil temp gauge flashes different values when the work light switch is on. any idea what that might mean? the manual is absolutely no help. I've ordered an amazon kit of brighter work lights, gonna add a second light to the top since mine only came with one and add another to the boom right beside the bucket cylinder.
@@JHulce That's great news. I went a loooonngg way around to determine my stock filter had just enough junk in it to cause issues. Lol I've been avoiding running mine in triple digit weather. It definitely heats up. I believe they say the hydraulic fluid starts to break down a (unknown to me) percentage after going over 60C. Getting more airflow inside the machine can't hurt. That exhaust is definitely part of the issue. I've seen some videos where the machine had a muffler wrap on them. Sourcing one might be a good plan.
@JHulce I have not experienced the flashing gauge values. I replaced my mini ex light with a flood beam style and it was a huge improvement. I added a 2nd so I could get more coverage. I'm probably going to put the same lights on the mini skid.
I have I have similar problem my machine doesn’t start at all. I am not sure what to do now. I placed an external electric fuel filter but still it is not starting