Тёмный

Citroen XM left hand display repair 

TheFrenchCarForum
Подписаться 51
Просмотров 26 тыс.
50% 1

A video to accompany this guide: www.club-xm.co....
You will need:
T9 Torx keys
Small flat screwdriver
Nail varnish remover
Cotton bud
Small craft knife
Small cable tie
6B pencil, HB may do but the higher the B the better
Tape
Spare bulbs

Опубликовано:

 

16 окт 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 10   
@rolystube6509
@rolystube6509 10 лет назад
I just fixed my display ! :) 100% of pixels, it took me less than 45 minutes. thank-you for this video.
@marcbrasse747
@marcbrasse747 6 лет назад
WARNING! This instruction describes a process which is extremely cumbersome and can easily damage your display! The reason: The mentioned glue has conductive qualities. It has been silkscreened into rows of very tiny rectangles on the foil of the display before factory assembly. Splitting the connection up and / or cleaning the contacts only reduces connectivity. I personally had a display on which only a few lines where missing and hoped to improve on that. All my attempts have however failed, in spite of the fact that I worked extremely carefull. The only way to fully re-establish connectivity would be to renew the glue but even if one could find the right type it is impossible to properly refill all the tiny individual connecting points without creating bridges between them. So now my display has become worthless piece of junk. Hail to the author of this video for that! :-(
@rolystube6509
@rolystube6509 10 лет назад
Good idea :) you clean that vid 96% alcohol and pencil om contacts, man you genius! I can't wait till i try to fix my one. I hope it works.
@KitKat-ts4wp
@KitKat-ts4wp 3 года назад
Can you use silver conductive lacquer instead of a pencil?
@Nikoxion
@Nikoxion 9 лет назад
I was a bit sceptic and still am, because I actually now have LESS working pixels. I will re-do it tomorrow and see if I can get it done better
@Nikoxion
@Nikoxion 9 лет назад
Okay now that I did it for the second time I got it working very nicely, but I'll you guys a hint from a Citroën forum that I should have known: "If the flexible cable is still strongly attached to the PCB and the display, don't try to separate them forcibly. Restoring the compressing force of the rubber band is usually enough in this case. Simply turn over the band so that the previously unused, thicker strand (that used to be in the recess below) is situated below the display glass now. Reassemble everything and chances are you're good to go." They also show you how to take the dashboard apart. citroen.tramontana.co.hu/electrics/missing-pixel-columns
@enizgelmez7645
@enizgelmez7645 7 лет назад
How is the 307 display change LCD connector help me
@bxundxm
@bxundxm 12 лет назад
Awesome!
@domuskas1
@domuskas1 11 лет назад
i dont understand with what you are cleaning
@xm222
@xm222 3 года назад
An interesting movie 👍😊
Далее
ОТПРАВЬ СВОЕЙ ЛП/ЛД
00:10
Просмотров 134 тыс.
БАБУШКА ВСЁ ИСПОРТИЛА #shorts
00:24
Просмотров 531 тыс.
The Citroën XM Story
18:07
Просмотров 760 тыс.
Citroen XM 3.0 24V- Old School Engine Diagnostic Tool!
14:35
Citroën XM Barn Find - First start in 20 years?
16:19
Living with a Citroen XM. 7 month review.
6:59
Просмотров 47 тыс.