Comparison: Acerbis Oversize Fuel Tanks for '24 KTM, Husqvarna, and Gas Gas Dirt Bikes

Подписаться 39 тыс.

Просмотров 4,8 тыс.

50% 1

Jeff compares the new Acerbis fuel tanks for the new chassis KTM, Husqvarna, and Gas Gas dirt bikes. These provide a substantial increase in range for enduro riding, dual sport, and desert racing.
Features:
• Includes all necessary hardware
• MDR gas cap be used on break gas cans or standard fill
• Used and endorsed by top riders world wide
• Works with Trail Tech fan kits
Shop Slavens Racing for oversized fuel tanks:
Acerbis: slavensracing.com/shop/large-...
IMS: slavensracing.com/?s=ims+fuel...

Спорт

Опубликовано:

31 янв 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 41

@2wheelsoffroad730 5 месяцев назад

I've been testing and tuning my 2024 350 XC-F Desert race build and like you I haven't run into any fuel issues. Off-road I've ran the gas tank down to a 1/4" - 1/2" of fuel in the wings without out issue on 3 occasions.

@slaverace1 5 месяцев назад

Hello: Thanks for the information!

@barnescycle 3 месяца назад

I just ordered the 3.1 from yall today. Thanks for the comparison it really helped 👍

@slaverace1 3 месяца назад

Our pleasure!

@crashedking1931 Месяц назад

How do you like the tank is it bulky.

@slaverace1 Месяц назад

@@crashedking1931 I use it all the time for trails and dual sport. I don’t even notice the additional width.

@barnescycle Месяц назад

@crashedking1931 not bad at all but now that gncc season is over I'm going back to the sx tank for motocross

@mikeburnett6222 5 месяцев назад

Good job Jeff, 😊

@slaverace1 5 месяцев назад

Thank you.

@davidzelkowski9948 5 месяцев назад

I wish they would have incorporated the radiator shrouds into the tank like their tanks for the older bikes. That helped keep the center of gravity lower. Of course there might have been issues preventing them from going that route.

@pauliemars 5 месяцев назад

Thanks Jeff. So when did the 4.0 become available? I just bought the 2.9 for my 501 as that was the largest size available last week. According to the internet. I tried to buy it from your shop but was told that 2.9 tank wouldn’t be in stock until end of march.

@slaverace1 5 месяцев назад

Hello: Acerbis does not even have a part # yet for the 4.0 tanks for `24 HQV models. We only have the KTM 4.0s in stock. We don't expect them until the end of April.

@slaverace1 5 месяцев назад

We just received 2.9 gallon Acerbis HQV tanks slavensracing.com/shop/large-capacity-fuel-tanks/ today and have more arriving next week. We also have IMS options in stock >> slavensracing.com/shop/large-capacity-fuel-tanks-for-husqvarna-by-ims/ .

@MrHumpo75 5 месяцев назад

Any Jeff idea when the Husky 501 4.0 ver will be out?

@slaverace1 5 месяцев назад

Hello: Acerbis tells us they will arrive the end of April.

@adamniswonger8015 4 месяца назад

Any reason a set of KTM plastics wouldn’t fit on an FE frame? Maybe airbox swap as well, but I’m not even sure that would be necessary, either. Just thinking since I am buying a seat and a second set of plastics for my new 24 fe501s.

@slaverace1 4 месяца назад

Hello: I'm fairly certain that KTM plastic won't fit.

@Aldershot1993 5 месяцев назад

Awesome. "Worry about your head not your junk."

@aaronmcelhinney1436 5 месяцев назад

Do you know if Acerbis makes a dry break system and or dump can, like IMS?

@slaverace1 5 месяцев назад

Acerbis does not offer a dry break but the IMS system fits well and we also have their dump cans. Check them out on this page please >>>> slavensracing.com/shop/dry-break-system-by-ims/. We also have these >>> slavensracing.com/shop/low-profile-dry-break-gas-cap-by-hunt-racing-products/

@mcgaryracer Месяц назад

How do you get to the oil cap to fill up the two stroke oil

@slaverace1 Месяц назад

Hello: We now have tanks with clearance for the oil spigot. slavensracing.com/shop/large-capacity-fuel-tanks/

@mikewest7585 5 месяцев назад

Any Idea when they'll have them for the 2024 TE300?

@slaverace1 5 месяцев назад

Acerbis has told us we will have them in April. The day they are available we will post it.

@motourge3061 5 месяцев назад

Is the 4 gal tank a prototype? I called Acerbis and they said they won't be available until late March or April?

@slaverace1 5 месяцев назад

Not a protype. These came direct from Italy to the US distributors.

@MrDirtrdr22 5 месяцев назад

Im running thr acerbis 3.2 on my 24 300 xcw, i have fit the oil fill cap as well. I shared a video if it. Clears the fan and everything

@edwolfe1397 5 месяцев назад

Hey, had seen your vid before then saw this comment. Went back to it for another look but... nothing different..?? you don't finish it out with.. I did this, I shaved that, now it fits ??, works ??, doesn't ??? Jeff has been running the same tank just without mods. If you made it work please show us what you did.. Thank you much and Good Job..?

@MrDirtrdr22 5 месяцев назад

@@edwolfe1397 yes i am extremely behind in my video updates. I am also getting a better camera, not using my phone to record. I will be posting an update soon. All i did was use a heat gun and slowly mold the upper part into itself, under the fuel cap, to clear the oil cap. Its not the fastest way t9 remove the cap as it used to be, but its doable eith out removing the tank.

@edwolfe1397 5 месяцев назад

@@MrDirtrdr22 there it is.. A heat gun to mold the tank backwards and free up the space for cap removal.. Brilliant and simple.. Thank you much.. I will now probably get the tank.. :) Thanks again..

@edwolfe1397 5 месяцев назад

@@MrDirtrdr22 hey, do you have a part number for the tank? They have several under 3.2 and what looks right says it doesn't fit which is correct but.. you have it figured out.. again, thank you thank you

@MrDirtrdr22 5 месяцев назад

@@edwolfe1397 i just got confirmation today from acerbis, saying The new 3.2 gal tank specifically for the 2024 XC-W will not be dry-break adaptable, but the mold for the tank has been slightly modified to accommodate the oil cap. Other than that, the tank is exactly the same as the tank you currently have. they are in the works to release a new 3.2 that

@codyhall1091 5 месяцев назад

wish Jeff would do a video on the bullshit chain tension guide as it’s way too tight following the OE spec

@slaverace1 5 месяцев назад

What year and model bike are you referring to?

@BradSheasby 5 месяцев назад

@@slaverace123+ New Chassis. There are videos showing that the chain tightens substantially more than in previous years as the swingarm swings upwards due to the geometry. Many feel the “tightness” or “stiffness” some experience in the new chassis has more to do with the chain being too tight more than the chassis or rear suspension.

@BradSheasby 5 месяцев назад

@@slaverace1 ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-iRiP-iIp-Tk.htmlsi=4pc16-AkWDkra6mb