Conveyor Broken Bearing Replace On Jobsite 

At least a piece of wood to hit on instead of the bearing itself. Also noticed the grease fitting being trapped on the bottom.. he should of put the bearing on with the fitting on top so that it can get grease when needed.

Yes that was correct but sometimes it doesn't follow the basic rules Thanks and noted next time@@900fam

I'm new to it what would u use rubber mallet.

@@brianberson4169rubber mallet is okay but brass hammer works best. Also never hit the bearing like this guy. Get a drift and lay on face of bearing then hit with brass hammer. U should only hit the inner race when working with bearings.

Thank you Sir

^^

Your correct buddy. video shows how to do it in basic ways but it's up to maintenance guy how they provide proper tools for every project available.. in that time we did just to run it for it will needed it very badly in the middle of busy operation..

Yap.. If frequently or your routine in field

Thanks

Thanks 🙂

Yes Buds, you can use any hammer as long as you are comfortable using it. Thanks

Nope but its up to you if need so

Thanks

And also forgot to put his personal lock on the disconnect.

Yes Buddy. I ms to show in my video about installing LOTO before starting the project. Thanks for reminding me appreciated.