My stupid remote that has to copy the codes is not flashing at all at start when clicking A+B. It starts to flash after 5 seconds then long flashing. What the hell am I doing wrong?
Hi, I tried to reset a Sonoff universal remote (433 Mhz) by pressing A+B button, but the led remains steady RED. How can fix it? Another question, how can I replace the battery ? thank you
Tried cloning my garage remote, and everything went as should, light on the cloned remote is solid blue, which tells me it has copied code but does not operate garage? any ideas ?
Press A and B simultaneously until LED flashes thrice then release B while keep pressing A, then press B 3 times and you will see led flashing continously then remove hand from A now the remote will be erased from codes then press and hold A on the copy remote and then on the original remote. same for B
How do I connect a new original device. It seems I have two original remotes. One works. And the other doesn’t just replaced the batteries to start testing it
One original remote only (pairing) support automation devices, If you want to pair another one use a clone/copy remote that remote should copy the wireless frequency code from original remote.
Reset and copy looks successful and it works fine for the very first time when I first press the button, but then it "forgets" the code and never works again unless I repeat the whole procedure. Any idea?
With me, my garage door opens but does not close. And I can only open my garage door once, and when I close it again with my original remote and then want to open it again with the cloned remote it won't go I don't understand :(
@@FrancescoBaldacchini i figured. Turns out there was an issue with the C button. Something made it stay pressed and i had to remove it. Might be an imperfect contact somewhere.
I can go trough the first steps easily, but when I try to copy it the light flashes few times then stays on. Can’t seem to get it to flash rapidly. What am I doing wrong?
