I have a question about the metal bar you have on here where you put your weed eater. I have the 6 x 5 Suncast shed and I cannot an accessory to hang my weed eater from. Where did you get what you used and how did it attach to the Suncast shed?
The unit has slots made for them to sit into. You're supposed to screw them down on the ends but I figured they fit tight enough that isn't really needed. I may be proved wrong.
Nice Job! I have a question, I have the BMS6202 Suncast shed, I just recently assembled it, I have a gap at the top back inside of each corner at the roof, about a 1/2 inch high and a inch long, I'm wondering if that is supposed to be there for venting or did I not put the roof on right, I don't see that gap in your video, do you have a gap there? thanks.
I bought the 3x5 Suncast shed and there is a small gap all along where the roof meets the wall panels. I've read that some people like to caulk all the seams to keep bugs out, but I think I'm going to just glue some bug screen up there so I can still have a little air circulation on the inside, just like you would with a typical wood shed.
There are slots moulded in for them. I cut them to fit the notches moulded in and then held them in place at the outer edges with screws from the top, down thru the wood into the shelving notch. Hope that makes sense. The shed owners manual shows how to do this and has a template for cutting the shelving.
You can get the plastic ones from Suncast. It is a bit difficult to get ahold of them but you can do it. The metal bolts I used... Honestly I have no idea what size or thread count or pitch.