Cub Cadet XT1 LT46" Transmission Repair | Low Fluid 

Thank you for taking the time to make this Briley

I got the 50 inch deck with the same problem. You can remove the battery. There are 2 metal straps that support the battery and they are removable. You should be able to access it that way without removing the transmission in order to fill it back up or maintenence.

Great fix saw the other video too you guys showed me all these machines can be fixed I have a cub cadet GT1554 great

Thanks man, this is exactly what I needed to fix my cub cadet. Great job!

Thank you! This is exactly what my LTX1050 is doing! I did try to bleed the air as I saw on another video, but it didn't make a difference, so I suspect that it's low on fluid.

Thank you Briley been having the same problem going to try this after work tonight!

I have a 2014. You can remove the battery under the seat and the fill cap is right there.

How not to!!! Put in new Seals since you know they are leaking. Powerwash the unit before opening it up. You have likely destroyed that special vent. You may find there is a rubber plug beneath the fan for filling. There are 2 compartments in that tranny. They also need to be vented by fwd/reverse movements. Parts falling off and dragging. Call Tuff Torx for seals. Tenn.

Advice on getting seals! Take the old one out and get the seal number. Get online and type seal number in and hit enter. You will be surprised at what you find.

Keep a eye out for leaks on trans or axles seals That’s where the oil leaks out most of the time Replacing axles seals are easy and fill up trans 😊 I just dropped the trans and turned over to drain 😊

can I ask does your white fan back there spin easly . mine is so tight that I can't spin it by hand

I have a very similar issue with my xt1 42". Out of nowhere the forward and reverse gears stopped working. Took off the deck and cleaned it and checked the belts. Is it more than likely the fluid being low that would stop it from working? I also know there is a switch that when you press for reverse, its connected to the transmission which makes it go backwards. I just don't know if that might be the issue. I'm going to mess around with it and see though. I guess if that doesn't work, I'll pull the transmission. Don't see any leaks though so, I'm not sure what's going on. Appreciate the video though, as it will help get it off if I need to.

Mine just grinds when you try to go forward and doesn't move. Reverse doesn't work... Belt and Pullys look good... Should I check the Transmission fluid?...

Great video, Thanks for posting....What did you use for fluid?

Awesome i’m about to check the fluid in mine not moving

If only there was a machine that could pressurize water to get dirty mowers like that clean.

I'm seeing 20w50 used

Thanks man!!! Merica🤘

Mine doesnt have a pop off plug it has a allen key that wont come off just stripping

Hahaha, all you had to do was remove the battery to get to that filler plug. You went through all of that for no reason.

What did you find for seals?

Hey my ltx1050 started making a horrible grinding noise and is really slow getting my fat ass up even a slight hill now. Never did that before. Any ideas?

𝐩яⓞ𝓂𝓞Ş𝐦 🙌

20w50 for cub Cadet rear end

Thank you for taking the time to make this Briley