In this video I show you how I regeared my Dana 60. This axle is from a 2005 Superduty and will be going into my Jeep Wrangler. This is a very complicated process and can be different for each install. This video is not a step by step instruction, but more of a means to help you decide if you want to do it yourself. Check out some more info online and do plenty of research before trying this yourself.
www.pirate4x4.com/tech/billav...
My final Specs:
Pinion Preload - 25 inch pounds
Backlash - .008”-.007”
Gear Pattern: Good haha
Be sure not to skimp on any steps! Make sure bearings are fully seated and lubed with gear oil!
Part numbers will be posted soon after I drink my coffee
5.38 Thick Cut Gears : amzn.to/2WRSF7t
Zip Locker 4.10 down Case (for thick cut gears) amzn.to/2UpzzJg
Master Install Kit amzn.to/2IhFNn0
1/4NPT tap amzn.to/2IqapTk
Calipers amzn.to/2WUzSIU
Dial Indicator amzn.to/2UIDyzP
Yukon Bearing Tool amzn.to/2C6O6yj
5 апр 2019