DeWalt impact driver anvil and chuck replacement 

*I absolutely love this set **MyBest.Tools** should have upgraded to the 20V sooner. The impact driver is a must have for driving screws; compact and all muscle.*

I just wanna say thanks brother. Because of your video I was able the change the anvil assembly for $20. Instead of spending $150 on a new drill. You're the man 🤜🏾🤛🏾✌🏽

Hey man! just wanted to say thanks a lot for posting this video, it was super helpful in the repair of my dewalt impact gun! I really appreciate you taking the time and my repair was a success! Thanks again!

The chuck spring is dewalt part NO78434. The little steel ball amazon will sell you that does in fact fit is N089668. That ball number is listed black and decker but fits. You might not have to replace the little anvil thing or take apart the whole gun. I just removed the snap ring and the chuck slide itself and that was enough to repair the common broken spring.

Very good video for fixing this kind very common problem! You save my time and $$!

Thanks man awesome video only one that I found that actually did the chuck and the works got my gun fixed thanks again

Hey Brendon love your vids. FYI I use a mechanics pic to remove the spring. Makes it easier to do.

I was planning to do it but then I figured out that I need my drill to take out the screws \m/

Thanks. Very helpful. Just did mine today.

Thanks for the video, just what I needed.

Thanks for what you do....Lighting was VERY BAD of subject matter!

good video brendan, just a little thing, if i were you, id have cleaned everything and re-grease everything with new grease it doesnt need much just a little

Im just going to replace the spring lol. I bought the new 20v brushless set. Now i have 2 awesome drill sets with a small repair.

I have the opposite problem damm thing never what’s to come out . Thanks for sharing with us 👍 .

Thank you, very useful!!👏🏻

This helped. Thank you!

Thank you for this video.

Why my do just hammering after assembly 😅

How do you know if anvil is worn out? I replaced spring that holds ball bearing and bit was still not holding well. Should I now replace anvil?

Please, may you add part numbers of these parts

Is it essential to take the chuck spring out in order to get the gearbox to come apart?

Is the anvil hollow? Reason I ask is because I have a Brocken drill bit in mine

You can bend the retainer with a flathead

Amazon had this drill in a drill only without battery for $59 ..wouldnt it just be easier to buy a new one...lol