Diesel Heater Caravan Installation Review Settings Adjustments. Jayco Caravans 

0:01 Installation, noise and battery consumption 6:49 Controller settings, adjustments and controls 13:01 Startup 16:14 inside dB noise 17:00 Underneath installation 23:41 Diesel tank 25:06 Outside db noise 26:55 Shutdown 29:39 Final say and CO alarm

Best explanation I have found on these heaters. Very thorough, other people gloss over so much of the details that I wanted to know about the install and running procedure 👍

Very important information thanks, greetings from ireland.

Hi Tim, very precise and informative video, great tips as well, thank you so much 😊

That was great. Many thanks - just finishing my installation now. The hardest part was finding the sweet spot to put it!!

This has been the best clearest video ever. Great comprehensive work. Congrats.

Nice video, however please move your muffler to vertical as it has a drain hole to allow water to escape, especially if your exhaust doesn't flow downwards, unless you have other drain holes on the exhaust

I just bought a 2nd hand camper trailer with a diesel heater installed. I pulled the whole thing apart looking for the fuel tank, wasn't till your video I thought to check the 20L jerry on the drawbar. Yup, plumbed to the heater complete with an inline valve. Thanks for tip off!

Great Video. We got a cheap Diesel heater a bit ago and just haven't installed it in our DIY camper rebuild as of yet. Hope to do it so. Great informatio, Thanks for sharing 👍up my friend

Great video! I have one on order and this video will really help me during the install. Thanks!

Great set of descriptions and help info

Great work and very informative.

Great ,well explained video Tim 👍

Great video mate.

Excellent video. Thanks.

Great video. Thank you

Very nicely explained! Thanks for that. I am going to mount a diesel heater in my caravan, because we are gouing on tour through Europe in winter. To rely on gas and electrical only seems not a great idea. Good to see that the diesel tank can be mounted a longer distance away from the heater itself. By the way: I have never seen a caravan with expandable canvas here, we only have those white aluminium ones. :-)

Great video very helpful

Great content mate valuable info 👍 subbed 👍

The PF setting is the heat of the glow plug🙂. Great video btw👍.

your exhaust silencer should be mounted with the condens/moisture hole down.

Great tube Timmy

Hi Tinkering Timmy! Thanks for taking the time to produce this video... well done! I've installed a very similar unit in our van as well and love it. I was admiring your wall clock and was wondering where you got it? It would make a nice addition to our van. Thanks.

Thanks!! I'm about to install mine in the bus and am nervous about it.

Great video but I believe your muffler should be mounted at 90 degrees to what you have it with the drain hole at the bottom to allow condensation in the muffler to drain away to prevent corrosion

Great video and the best I’ve seen to date. One question. Where you fitted the fuel line the the fuel pump using the 30mm rubber fuel line did you just butt the plastic fuel line to the pump?

Good on ya

Hey mate nice vids. I’m thinking of getting a diesel heater but I’m just in a small van and don’t really have room to mount the fuel tank outside anywhere. I was just going to secure it in the van near by the heater, ( not too close) do you think this would be a problem safety or noise wise? Thanks

So is some air in the line unavoidable? My heater blew stacks of white smoke again but no errors and it came clean afterwards got me stuffed and stressed as we love the heater so much don’t want it to foul plug and be without it

Thanks for the gr8 video. I think your battery might be on its way out the heat plug usually draws about 10 amps. If your voltage drops that far down, it won't be long before you will need to replace them. Btw, do you Have a link to the heater pls?

Thanks very much for your informative video. Do you have a background with this stuff because your terminology was very precise?

great video. I am putting mine in tomorrow but not before i go to bunnings to pick up downpipe pop. What did you seal it with. Thanks

My heater has been running fine last two days but it smoked up white cloud today on startup. I have been running it on manual lower settings so fingers crossed it just hasn’t conducted a good burn like it should at higher temps so I’ll run it on auto from now to see if that helps running flat out to start. The pump is approx 3m away from the tank I did that arse about but it didn’t present as an issue first two days after priming etc. I re mounted the filter vertical instead of parallel as recommended due to perhaps excessive air entering. Pump in on a 30 degrees as yours is, have you had any issues with smoke? Do you have practices like turning it up to burn off before OFF? Thanks for help 👍🏻

What is the white box next to it? Can this heater be installed in the same space as the battery?

nice video mate can you put a link to where you got this heater from please thanks

Have you had any one say anything to you regarding use of them In caravan parks ??

My arrows are on the left side. When entering password there is no paddlock icon and I can't get it to save settings when I replicated the settings. Do you have any insight into how I can save the settings?

Is it critical the exhaust clears from underneath the van?

When priming the pump will it stop itself after a certain amount of time or do you have to turn off the priming manually? Where my heater is located I can't access the fuel connection as you did and drain into a bucket.

SCREEN CODES: PF-5 = Power to the Glow Plug

But can it do Fahrenheit for those of us that don’t do C?

Did you find it necessary to add the intake vent for the heater to suck air into the unit from the van cabin pressure?

Does your flat plate get quite hot?

How long is your fuel line?

I brought the German fuel pump $24 EBay

Hi , on the yellow diesel container ! Where did you get the fuel line connection on the yellow jerry

your muffler should not be set on its side. hole should be pointing down