DIY 2013 2014 2015 2016 2017 Honda Accord Replacing Driver Side Transmission Engine Mount 

Thank you! Appreciate the support.

Thank you for your support. Hopefully soon I’ll be doing the other 2 mounts as well.

What was the symptoms on your daily drive

Good Luck! We do plan on making a video for the rear mounts. I agree the service manual isn't always the greatest. Cheers!

Good tip! Thank you.

Glad I could help

Thank you for sharing the knowledge. Appreciate it.

It should be possible. I removed the bracket as the mount that was purchased included one.

It's possible to remove it, but sliding it back in to align the wholes for the screws is difficult. The bracket puts a lot of tension on the mount. Instead of worrying about stripping the threads I removed the bracket as well, since it's not too much work.

Thanks for the reply. Haven’t done the rears yet but may still make a video on them just to show how to replace them. That’s interesting as the mounts that have been replaced so far have made a difference. Was this right after you installed them or over time?

@Mobile Car Mechanic it was right after replacing them, I put about 50 miles on them to see if they would break in some, but no difference. I'm gonna have to put my two old ones back in.

Also, I had started up the car before doing those 2 last ones just to feel how it improved, and it felt great

Bad Mounts can cause Vibrations in reverse or drive.

Thank you!

Definitely a mount issue. We hope to get the rear mount video out soon. Cheers!

Did you change , any mounts .if witch one ? Did shake stops

@davidkuzmanov3488 ended up being the passenger side and front mount, just make sure to get oem. I got aftermarket at first and it made it vibrate worst

@@JoeVil let me know , from where you buy Oem mounts. Thanks.

@@JoeVil btw i See now, when idle at stop- shake on brake pedal. Can this be , transmision mount or maybe need Valve clean ? And it not continous , for long.sometimes did , and some not. What do you think.

Ours came with the bracket so we decided to use it but it isn’t necessary to change it.

40 lbf·ft or 54 n-m

@@MobileCarMechanic thank you ! Awesome video btw really helpful!!

@@MobileCarMechanicdoes the 40 ft lb apply to both 14mm & 17mm? Sorry I’ve gone through the video 3 times trying to see if you mentioned torque spec :/ until I found this comment! Also thank you for being the ONLY video on RU-vid showing how to replace this upper transmission mount on 4cyl 9th gen accords! Literally have been scouring forums and videos and you are the ONLY one so I appreciate the time you take helping educate us!

@@MobileCarMechanic​​⁠ Hey just wanted to add that after my original comment, I continued to scour the web and after a few different variations and wordplay I was able to find one instance of this upper transmission mount being mentioned. They were kind enough to add the installation manual taken directly from tech info. In it states everything you’ve shown in the video. Since my point was to find more clarification on the torque spec, the following is what the manual says to do. It states to attach the transmission mount with the entire assembly (as you’ve shown), then you loosely install the upper transmission mount bracket bolts (3 bolts on the bracket), and you tighten the transmission mount bolts (3 bolts closest to driver side wheel) to 40 lb ft. You then lower the vehicle back down and remove the wooden block from the transmission. At this point it states you can now tighten the upper transmission mount bracket bolts to 44 lb ft. It seems you followed exactly what the manual states. Hopefully this comment will help anybody who is more technical when it comes to torque specs like me and thanks again for all you do educating us with your videos!

It sounds like a mount for sure. I’d run your engine and have some one press the gas pedal on and off and see if the motor moves. Look for any cracking or sagging where the mount is.

@@MobileCarMechanic OK... thanks a lot...

Started feeling vibrations inside. Ended up buying a whole mount kit and decided to replace them all as they have 150k miles on them

@@MobileCarMechanic oh ok. Yah my accord has 102k on it. At idle it vibrates pretty hard once off idle its fine.

That was what we were experiencing as well. The passenger side mount I believe was the issue but wanted to replace the others as I’m sure they will fail shortly after.

​@@MobileCarMechanicthat is my fear as well. Did u do a video on the rear mount?

Thanks for the clarification. Cheers!

@@MobileCarMechanic What if I loosen this one bolt holding the bracket to the mount and install the new mount and tighten only one bolt to do the job quickly sacrificing the new bracket?!🤔

Glad you like them!

That’s a bummer. I’d keep pushing it or try to goto another dealer if you can that accepts the warranty. I’ve not done this on the V6 models. I imagine it’s not that much different.

Thank you!

This is a 4 cylinder.