DIY Scribe Tool and How To Use It 

Thanks a lot for the comment I really appreciate it! Got a few videos half filmed so keep an eye out for them soon😁 thanks again!👍🏼

Thank you!

Appreciate the comment! I have a list as long as my arm of video ideas just making the time to get some done. Currently planning on turning my garage into a little workshop over this winter so will be much easier then. Stick around and i hope to get some consistency going next year😄 Thanks again👍🏼

@@mwjoinery Just subscribed so I'm glad you have plans to upload more soon, can't wait to see more of your videos in 2024. Cheers from Australia 👋🐨

@@nalanimulcahy8451 Really do appreciate it! Just bear with me i will get some made as soon as i can!😆 Managed to retrieve a huge 8”x8” solid oak gate post today so just jotting down some ideas what I can turn it in to as we speak! Just need the workshop up and running and I can get making them. It’s crazy that you are watching from so far away. Could do with some of the Ozzie weather over here that is for sure!😆 Thanks again👍🏼

Thank you for watching and leaving a comment! Let me know how you get on if you do give it a try😄👍🏼

Will do pal

Thank you!! Really appreciate it👍🏼

You’re very welcome! Thank you

Thanks a lot Terry! Yeah, i leave the majority of my tools, even personal ones at work because you can’t be sure who is about these days can you!

Yeah it is very simple! Thank you for the comment👍🏼

Thank you👍🏼

Thanks a lot!👍🏼 yeah it was just an off cut of mdf I used for the video but it will work with material really. MDF is very easy to mark and cut so it may take a little bit more time with timber but should still be able to get a good finish!😁

Thank you👍🏼

Thanks for watching! It’s hard to explain over a message but i will try my best. The easiest way, is to scribe your panel to the wall first and leave plenty overhanging. Keep altering it until you get it nice and then do the straight cut on the front edge. If you have an edging or something on the straight side what can’t be cut. Overhang the panel and level it up. If the panel overhangs the finishing position for example 40 mm. you set the scribe tool to 40mm from the pencil to the point. Once that is scribed the panel should go back the 40 mm and the front edge should end up where you intended. Hope this helped? If not, let me know and i will try and explain better. Thanks👍🏼

Thank you!