In this video tutorial, I will show you how to make a simple chisel and plane sharpening jig out of scrap wood It's useful and easy to build woodworking tool
топчик,просто и эффективно,только я бы еще добавил на верхней дощечке тонкую металлическую пластинку поближе к краю для упора ножа или стамески,чтобы каждый раз не ловить 90 градусов
@@MazayDIY As I prepared to make this jig, I looked at the castor wheel I had to emulate yours. There's quite a bit of play in the wheel, going up and down, side to side. This is standard for all the castor wheels, part of their manufacturing process. Its different to using bearings riding on a piece of round stock which would be true and stable. Does your castor wheels exhibit movement or flex in their chassis and if so, does this affect the sharpening jig?
@@MazayDIY well, I did it as promised. I have sharpened a chisel and a small bullnose plane iron (Stanley 75). The former was a very badly chipped - my fault - MOB French made chisel and the latter was a new acquisition with about 4 different angles on it. I used two old stones to do it, very cheap ones. I did well over 1500 push pull motions to totally redo the chisel, and about 1000 on the plane iron. I learned later on that a piece of 320 sandpaper on top of the rough stone did more metal removal than the stone. What a time saver! Of course, each was hair shaving sharp after stropping, but the Stanley 75 just plain sucks, digging into the wood despite it being properly set up. I love my jig, thanks for showing the way. Made mine from oak and fancy brass wing nuts. Also added 400 grit sandpaper to the insides of the holding area of the jig to grasp the chisel/iron better. It will marr the surface though, so do be careful. I was finding that the oak, despite not being polished, was letting the object shift ever so slightly despite being cranked down super tight. Last observation is that the castor wheels arent perfectly round, nor spin perfectly round on their axles. But, worked well enough for jam. Cheers!
Норм всё, не надо по наждачке катать, отрезать её шириной меньше растояния между калесиков, ещё у автора нижняя фанерка толстовата, если сделать тоньше то можно точнее регулировать угол заточки подкладывая под наждачку листовой материал опять же по ширине наждачки
Это мебельные ролики, взял в местном магазинчике у дома вроде Самоделкин или 1000 мелочей. Если не найдете, то в магазине мебельной фурнитуры точно найдете
I really hate it when people don't edit there footage to the shortest time possible as to not waste others time. Yes we get it your trying to get the bolts to set flush we don't need to see you tighten and loosen both of them all the way.