DON’T DRILL IT! VICTRON Lynx Distributor with Smart Shunt, Battery Disconnect & LED Lights Working!

Подписаться 2,2 тыс.

Просмотров 6 тыс.

50% 1

This tutorial demonstrates the process of directly mounting a Victron smart shunt and battery disconnect to a Victron Lynx WITHOUT DRILLING out the holes. It will also cover building a wiring harness to make the LED lights functional.
Attached are links of the less common products used in this tutorial.
Victron M10 distributor
invertersrus.com/product/vict...
Victron Smart Shunt
invertersrus.com/product/vict...
Battery disconnect
invertersrus.com/product/spar...
5v power step down
www.amazon.com/dp/B076P4C42B?...
M10x20mm brass bolt
www.amazon.com/dp/B0BRFRG85Z?...

Опубликовано:

27 апр 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 4

@RubenLakeSide Месяц назад

Very clean setup but tell us why you have power to smart shunt on powered side of switch instead of switched side. Thanks

@LakeTahoeCustomCampers Месяц назад

The shunt draws less than one mA so its not a concerning power draw. By placing the shunt before the switch it enables the user to monitor the battery status even when the battery is disconnected from the system.

@Wesmaster Месяц назад

I have the M8 Lynx Distributor, you think it would be fine to drill out the holes to make a setup like this possible?

@LakeTahoeCustomCampers Месяц назад

It’ll be just fine. Make sure to put the cover on before you drill out the holes so no metal shaving get onto the circuit board. Deburr the edges and put a little dielectric grease on the exposed copper after drilling.