Don't buy an LS Swap bench harness without watching this first! 

Love your laid-back style and don't care attitude

Finally a gen 4 Your the man!!

Awesome. I wish you have bought a ZJ Jeep and swapped an LS into it, so I could copy it :)

Love the LS based videos

Great information from your channel thanks very much 👍

Thanks J.R. I appreciate it

That’s cool JR

My gen 3 6.0 runs great! Now if the transmission I bought (rebuilt, allegedly) worked, I could finally take my first shakedown cruise. I found a local guy who is fixing the POS I purchased in good faith from one of the national re-builders, my advise? DON'T. Use a local little guy and get results, because I am paying tuition! Love your videos, Thanks.

Very impressive, this upload...

dont you need a terminating resistor between the 2 can bus lines ?

Pin 21 from the pcm where you connected to is keyed?

What is the name of the part you plugged into the computer

I have a complete doner vehicle... sooner or later I will have a key made to see if it runs. If so, it's going in a square body.

@The Driveway Engineer have you made a bench harness for a e40 pcm or ecu?

Is there any way to clone these ECU's yet like pcmhammer?

Jr gen 4 pistons in a gen 3 lq4?

I’m lookin in ur videos for some more info of how to wire my stand alone fuse block I have all my pins labeled an ready jus wanted a video for clarification ur help would be highly appreciated

First let me say that I'm not trying to be an ass. I really like a lot of your videos and I've learned a lot from them, but you really should have scrapped this video and made a new one once you figured out which pins were which on both plugs. I had to skip back 100 times and sketch out 3 different pinouts because i was following along with the parts you fucked up. How to videos need to show us just the facts and just the proper facts the first time because if you dont do that, youre going to confuse the shit out of a lot of people who are trying to learn something that they know MUCH less about than you do.