Door Access Control System - Part 1: Installing EM-Lock & BIOXCESS Reader 

No worries just put the captions in English in the settings and thank me later.

what type cable do you using for EM lock?

VERY USEFUL VIDEO.

what is the best way to connect biometrical reader to a turnter with a push button?

can I have the multi door access control for apartments

Can you turn the timer off? push a button and it stay lock / unlock until you push again.

i have one doubt ,Battery,load o/p,em lock, up this all k aft that ( input) wires where its goes to connect??????

Bisa atau tidak reader di combined dengan finger? jadi untuk masuknya menggunakan reader dan keluarnya memakai finger?

show the archeticture of access control

i have access control system its not working and programing card is not working how you can help me

I wnat to card access. all system. breck glos. em lock. push baton. reader.all

How can get full video

How secure is this? If you are using the onboard relay of the reader. If you rip it off the wall your door will unlock, because it's a fail safe lock. If you want security you should use the wiegand output and program it with a computer.

Good analysis. However, even though it's for demonstration purpose but the termination of the cable should be properly done as I noticed some bare conductors showing.

Ini barang senang faham..

2 door not working. Red led blinking. Any problem

how to termination only lock and door contact to the board .we need relay connection or direct connection

very nice

Where can I found this metal panel control with the powersupply.. with switch on off ... all powersupply panel that i found are with a suspicious power supply with no switch

i need the power supply unit can u give us a link

Useful

If this is a video anyone here is learning on.. make sure you cut your jackets all the same length... all in a 90 degree fashion.... Most of all your conductors need to be terminated so that they are not visable under the terminals.. he almost shorted a million times... treat the wire as it is hot at all times, you will not regret these tips. sounds arrogant, but I am one of the best at the craft. This stuff is not difficult to install, so you want to make sure when you leave the product on a customers property it looks like they couldn't do it themselves. They will be looking at it for the rest of the time they have it! If you are a novice I recommend you spin the cables with the jackets cut all the way back and secured together. Lable the jackets out of sight. get a lable maker and mark them at each terminal on the board. Good Luck!

when did soldering get replaced by a philips head? sweet

nice vedio

Hi get more details

woow good

If you don't have electricity (cut from company some hours) how does work all the system?? To opened the door?? :-)

very nic

I could have been the best video if you continued only in English

English convention I prefer it

Qual é a placa que você usa??

boss english only please... usefull video but hard to complete understand.

singapore layou

Klu door tu xlekat pe msalah nya.

ih hose a mess

why u started talking in different language in between?

Roses are red Violets are blue The title's in English, Then why aren't YOU?

💣 💣

your, not explaining anything....and you keep changing language!!

power ne

Ww

too much movements making it boring.

Sorry fella but your termination technique is rubbish. The stripped wire strands should be twisted tightly together, then bent back on themselves to give more contact area before inserting into the terminal. Also when terminating, you shouldn't have all that bare conductor showing outside the terminal.

Your video is horrible. You're not explaining anything. I was trying hard to follow you. I kept stopping and rewinding it, yet I still got nothing out of it. You kept talking in some language, no clue what you're talking about.