Electronic kits such as our UBMP4 are designed with through-hole parts to make the circuit easy to solder for students and hobbyists. The most difficult component to solder onto the circuit board is the USB-C connector, due to its low profile, closely-spaced pins. This video will show you an easy way to solder the USB-C connector by drag soldering using a wide, blade soldering iron tip.
To successfully drag solder a USB-C connector you will need:
• a soldering iron with both a small conical tip and a wide blade tip
• your preferred electronic solder
• a flux pen that dispenses the same type of flux that is in your electronic solder
• tape to hold the connector in place while soldering
Find out more about the products and learning activities on the mirobo.tech website:
mirobo.tech/
UBMP4 kits make a great introduction to microcontroller programming and interfacing. Take a look:
mirobo.tech/st...
Please subscribe to get notified when new electronics and robotics videos are released.
10 сен 2024
