No video :(

Drift E46 Hydro E-Brake / Dual Caliper Mod

Подписаться 1,1 тыс.

Просмотров 1,4 тыс.

50% 1

In this video we will be installing a hydro E-Brake and dual caliper on the E46 drift build. We used an Ebay handle with a Wilwood master cylinder, weld-on brackets, and Chase Bays lines. We also found a way to keep the rear wheel speed sensor signal to avoid limp mode.
269 Garage

Опубликовано:

23 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 8

@speedy12ization 2 месяца назад

Man savage set up, all working good with the speed sensor? And how about the welds how are they folding up seen as the arms are cast? Looking do same on out road drift bus 👌💪

@269Garage 2 месяца назад

Speed sensor works and the welds are holding fine thanks to welding all the way around and a proper pre heat cycle.

@speedy12ization 2 месяца назад

@@269Garage Thanks for the reply! Wasnt aware that you had to preheat cast, going to tack it with the flux core and take it to the local shop to weld it with the gas welder, been searching ages for a solution for the hydro so thanks!!

@269Garage 2 месяца назад

Also clean the heck out of it, no oils or rust.

@NikoliteZero 8 месяцев назад

Welcome back

@269Garage 8 месяцев назад

Maybe I'll regain momentum

@Vivianauxito 8 месяцев назад

We produce LED for AUTO, Are you open to doing any product review? If yes, How can we connect with you

@269Garage 8 месяцев назад

Not at the moment, we're pursuing a new shop currently. Been too busy to even upload archived videos lately, which I need to catch up on ASAP. Perhaps later in the future.