Dynabrade Sander Repair - How to Replace the Rotor and Blades

Подписаться 71 тыс.

Просмотров 11 тыс.

50% 1

Need help replacing the Rotor and Blades (Part 57113) on your Dynabrade Sander? Watch this how to video with simple, step-by-step instructions for a successful DIY repair.
Stay safe during your repair! Be sure to check www.fix.com/safety/ for proper safety procedures before you begin. Use of this video is at your own risk, without liability to Fix.com.
Fix Part Number: FIX10338983
OEM Part Number: 57113
Why you might need to replace the Rotor and Blades:
1. Worn down
What tools you need for this repair:
• Thin wrench
• Screwdriver
• Mallet
• Arbor press
The information in this video is specific to Dynabrade. To find a Rotor and Blades specific to your model, visit www.fix.com
Not what you’re looking for? For more power tool repair help click here: www.fix.com/parts/power-tool/
Where you can buy this part: www.fix.com/parts/sander-poli...
Connect With Us!
/ fixdotcom
/ fixdotcom
plus.google.com/+fixdotcom
/ fix.com
Visit our blog: www.fix.com/blog/
Don’t forget to comment below and subscribe to our channel!

Хобби

Опубликовано:

8 фев 2018

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 7

@Live4Ibanez 3 года назад

Thanks for this video. Was able to take my grandfathers apart and found it was seized due to a blade that was cracked and between the wall of the rotor and the housing. I'm going to polish the inside of the housing up and throw a set of rotors in.

@rustyplane 5 лет назад

I noticed a retaining ring on my sander just over the bearing. You didn't mention removing or replacing this retaining ring. On your video it appears to be missing. Is this an oversight on your video or am I missing something?

@jameshendrix8217 4 года назад

What about polishing the cylinder? There's alot of other stuff you have to look at than just replacing the rotor and blades.

@joserodriguez-th7ts 6 лет назад

Thats a great video but how do i know whats wrong wint my sander it just stop spining

@FixDotCom 6 лет назад

Hi Jose. Does the sander turn on at all?

@tylerbrandon460 5 лет назад

Do you not have to grease or lube anything during reassembly?

@dragerx001 5 лет назад

i would recommend when you go to screw cap cast ring in you add oil in the thread i generally just glob air oil all over it then screw on super easy. as far oiling goes i generally oil mine after i have it all back together i just put like 10 drops in air line let it flow threw motor with filter cap off so does not clog up filter but if you run it with out filter you have turn down speed or it mite explode rotor. Hope it helps.