Easy to Build O gauge 3D Printed Kit - 247 Developments GWR Hydra Wagon

Подписаться 24 тыс.

Просмотров 1,8 тыс.

50% 1

This is a great, easy to build 3D printed kit! The 247 Developments GWR Hydra Wagon gets a complete build and review in today's video. If you like the look of this wagon and fancy one for yourself, here's a link to help you out: www.247developments.co.uk
We are pleased to be sponsored by Train-O-Matic, makers of DCC chips and accessories that just work right out of the box. Visit their site at www.train-o-matic.com to see their full range of products! Also available through UK stockist: www.tramfabriek.co.uk/decoders...
We are pleased to be sponsored by Clark Railworks, specialists in high quality pre-owned model railways. Visit today for all the best new and pre-owned OO Gauge, HO Gauge and N Gauge models from all the major manufacturers: clarkrailworks.com
Join this channel to get access to perks:
/ @jenniferekirk
If you like the video and want to help me make more, take a look at my Patreon page: / jenniferkirk
Want to buy the mugs, t-shirts or hoodies? Go here: teespring.com/en-GB/stores/al...
Want to buy Jenny's books? Go here: www.allmousemedia.com/books
My website: www.jennifer-kirk.com/
Chapters:
00:00 Video start
00:25 Introduction
04:16 Sponsored by Tramfabriek and Clark Railworks
05:13 Overview
07:55 Planning the project
10:04 Painting the wagon
11:26 Adding the wheels
16:35 Adding the buffers
20:49 Adding the couplings
25:17 Running test
25:58 Conclusion
30:54 Thanks and Sponsors

Хобби

Опубликовано:

16 июл 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 8

@richardswiderski4985 2 месяца назад

Very nice kit Jenny I think that wire on the buffers were the spring.😊😊

@peterjackson-cheadleheath1182 2 месяца назад

Hello Jenny A great little starter kit build, even if some parts are hard to source, I'm not sure I'd have the patience to do those buffers and couplings but without any drawings/diagrams to work does make it slightly more difficult (5 out of 10 Peco not upto your usually high standards !). Nicely finished though Jenny. Thanks

@JamesPetts 2 месяца назад

You should do more kit building videos.

@dennisroots1529 2 месяца назад

Hi Jenny, the brass bit with the slot would fit on the rear of the buffer and the wire fits into these either end to give you 'Sprung buffers'. The wire at its mid point passes through the coupling as you did. However I can see the model may not have given you enough room for this. 🙂🙂

@dennisroots1529 2 месяца назад

Should have added, page 176 of Peco's product & modelling guide give a better illustration. R.egards, Dennis

@earlfreeman93 2 месяца назад

Jenny can theses wagons be fitted with 0 gauge NEM pockets and could they be set for 0-16.5 running.

@odilemahot2011 2 месяца назад

I like 3D, but buy hand is more with the end result but which ever you like we do find scratch building models on youtube, that are more like tips on how too but not the maths to convert from photos.