ENNOID XLITE V3 Smart BMS Setup & Configuration

Подписаться 14 тыс.

Просмотров 1,9 тыс.

50% 1

If this information has been helpful for you, please consider supporting the channel:
theboardgarage.com/store
/ theboardgarage
Follow me at:
/ theboardgaragellc
/ theboardgarage
00:00 - Introduction
01:34 - Waking the BMS up
03:10 - Connecting to Bluetooth
04:04 - General & Pack Configuration Explained
06:52 - Cells Limits
09:54 - Temperature Limits & Temp Sensors Explained
14:05 - Balancing
14:38 - Sleep
15:26 - Finishing Up & Checking
17:06 - Test Charge & Checking Charger

Наука

Опубликовано:

9 июл 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 15

@deanaoxo 4 месяца назад

Once again, filling my library with such valuable information, thank you.

@DoctorDugong21 4 месяца назад

Very helpful, thanks! Two hopefully quick questions. 1) Are the cell limits you show also appropriate for 18650 cells / a speed pack? 2) Can the humidity reading from the Ennoid be used as a diagnostic for water ingress, and if so what reading would indicate water ingress vs. just high humidity air coming through the gore tex vent?

@kevindionne1017 4 месяца назад

Great video Mario, thank you

@batterymooch 4 месяца назад

Thank you for this video!

@jakemauney1699 3 месяца назад

Love your videos! Super hype for my first battery from you

@andrewwilson983 4 месяца назад

Great video! Very informative as always! I love my V3, and I have to say I couldn’t ever run a “Dumb BMS”. Not being able to see voltage or temps would bug me to no end. Also, firmware 6.2 is out now!

@karlm5022 15 дней назад

is it possible to save cell data during a discharge?

@ed.floats 4 месяца назад

Thanks for the video - useful info in there! Could you provide detail on the 'Signal' menu? I can see how 'Charger Voltage Factor' could be used to calibrate voltage readout by the Ennoid but unsure what the 'Shunt Factor', 'NTC 25 Degree' and 'NTC Beta' values are used for? Many thanks!

@anthonyencarnacion7203 4 месяца назад

Is there any hope for my toyRus Neon Nitro battery replacement and software upgrade..? Max speed dead stop feature seems monumentally stupid..

@patryk888888 4 месяца назад

I have that setup and sometimes when I plug in the charger after I’m back home it won’t charge unless I turn off the board. What could be the reason?

@TheBoardGarage 4 месяца назад

In some cases, the software won’t allow the operational state to change to ‘charging’, if it’s in a power down mode or something along those lines. I believe that’s been mostly resolved in the recent firmware release. I’m not sure.

@patryk888888 4 месяца назад

And that would also explain that it only happens sometimes not always ?