EVOTECH CRASH SLIDERS INSTALL | HONDA CBR650R (ENGINE SLIDERS & SPINDLE) 

Thank you for putting this together! Followed along on my CB650R, wasn't all that bad. But the horn gave me a hard time.

I really like how you work. I have the same sliders, I too think these are the best ones in the market right now. Just wanted to point out one detail that may be wrong: I think the back bolts should be at 49 nm, and the ones in the front should be at 59 nm. This is how it is specified in the service manual. Other than that, I really liked your video and your work, I'm definitely suscribing.

Hello, quick question, does the frame sliders mount on the frames on both sides or it mounts to the engine case in some places.

What a stonking bike , she's lucky to have you : )

Hi where did you get the torque specs from? Haynes manual says the front bolts are held in with 59nm

Does frame slider sticks out from left and right equally? Installed them today on my CBR, and it looks like from one side it sticks out for 4.5cm, from another 5.5cm.

Thank you so much for this vid 😭 I was getting so mad this vid helped so much HAHAHA

Did you have an extra small spacer at 10:25 ? Ive only got a small and large one in my kit. Dont think you used it in this video either.

From where did u got the torque settings? Do they come with the installation notice ?

Hi mate i aint got a torque wrench just normal, should i go install it anyways if not what was the NM for the bolt and did u use any locktight

Hey bro. Just wanted to say thanks for going through this. I've just installed the same sliders, tail tidy and one bar end. I say one bar end because I can't get the left one off! If you've already put your bar ends on do you remember if the left one loosens by turning counter clockwise (left)?

Hey, I loved your video, and it made me buy those! I mounted them today and I love them, but... I have one part left over. It's one of the two small diameter shiny spacers. Like the one you install at 10:23 in the video. You also have two, but I can only see you use one. Do you know where the other one goes?

the crash bobbin on the side with the horn i had to grind 1mm off the spacer as it would not fit no way i tried everything so i took 1mm off and just got it to fit

Thats a nice box of tools. Who makes them?

Are these the same for the cb650r I been looking online and they don't have the bracket like your ones and I prefer multi point of contact ones? Thanks

Hi do the sliders come with the tools to install?

Yeah you are right, I have the R&G sliders and the evo tech is better. Great vid, I might have to grab that front spindle too.

Good job. Greetings from Spain

Thanks dude will be installing these tmw.

At 9:03, Don't EVER break a bolt loose with the open end of a wrench!!!!! Use the Box end!!!!!

Did you do all of this on the side stand?

Do this mount to the frame or the engine?

Are these going to do real work if the bike will drop down?

Where did you get the torque for each bolts mate?

what year of manufacture is it?

Do you need to loctite the bolts?

Anybody know if these will fit a 650F model?? Similar body but id be pissed if it didn't fir

謝謝☺️

Lavley!! 👍🏽

Where can I buy them?

I noticed there is an extra spacer (small ones)

I bought it, I hope I can do it.

Broooooo you paid over 200 dollars for these!!!!!! Tf I got mine for 90 bucks