Recommend cleaning up the welds a bit on the caps and joined tubes. takes a few seconds with a sanding flap disk and makes the quality look much better. Other than that looks killer!
I can relate to the 5 hours 😅 I’m new at this and to figure these angles and notches it does take a while when you only have a grinder to notch. Pretty clean work will be doing mine soon , cheers 🍻
Looks good. Some have already commented the same thoughts I had but one. Get yourselves a beadroller and add some details to that skid plate. As a beadrolling artist any opportunity on a flat piece like that is gold. Also you could have done some dimple dies as well, adds strength and looks bitchin.
How much did this run ? If I bought it off u time n material ... Looking for a rough idea no one makes this style so I'll have to do a custom one I assume looks awesome really makes the truck imo
Visually cool bumper, but..it looks like the uprights are touching the grill (or way too close) and the side diagonal pieces welded to the flappy mcflapperson tab have 0 support.