Тёмный

Farmall carburetor tuning and timing adjustment 

Dr rust
Подписаться 2,2 тыс.
Просмотров 14 тыс.
50% 1

We talk about carbs and timing then tune up the M
#farmall
#antiquetractors
#carburator

Опубликовано:

 

10 сен 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 19   
@lewiemcneely9143
@lewiemcneely9143 2 года назад
Sounds a lot better and you're right about running nit and getting it hot. It'll limber up then. BLESSINGS 2 U!
@DrRust
@DrRust 2 года назад
You too it already is running better I mowed a bunch with it
@lewiemcneely9143
@lewiemcneely9143 2 года назад
@@DrRust Can NOT beat the old rigs.
@DrRust
@DrRust 2 года назад
You’ve got that right
@lewiemcneely9143
@lewiemcneely9143 2 года назад
@@DrRust I've seen and dealt with the old and watched the new die outright. No comparison.
@DrRust
@DrRust 2 года назад
We have a jd compact tractor that’s 25 years old and it’s in pretty rough shape then I see international Titans and jd Waterloo boys that are a century old and wonder where we will be in 50 years
@Ironringbound
@Ironringbound 2 года назад
One of the nice features of an updraft is it takes a ridiculous amount of fuel to flood your engine.
@DrRust
@DrRust 2 года назад
Yes but if you do good luck getting it cleared out
@ThefarmLife.
@ThefarmLife. 7 месяцев назад
@@DrRustcould you help me ,my updraft carburetor is pouring gas out of the air intake side
@DrRust
@DrRust 7 месяцев назад
Your float is probably sticking try taking the carburetor apart and clean it up
@ThefarmLife.
@ThefarmLife. 7 месяцев назад
@@DrRust it wasn’t doing that before I took it off..I took it apart & cleaned it for the first time and when I put it back together that’s when it started
@DrRust
@DrRust 7 месяцев назад
Take it back apart and make sure the float moves freely and doesn’t touch the side of the carburetor causing it to stick then check the needle and make sure it moves freely Then make sure that when the float is parallel to the upper body of the carburetor when the needle is closed
@wattsup8407
@wattsup8407 4 дня назад
I would assume this applies to all updraft carburetors? I have a 1980 Lo Boy running rich and adjusting doesn’t help.
@wattsup8407
@wattsup8407 4 дня назад
Had a waited a few minutes I’d have heard that I’m doing it wrong. 🤣
@DrRust
@DrRust 4 дня назад
@@wattsup8407good luck Try lowering the float
@darcygulka5627
@darcygulka5627 Год назад
I replaced the points and condenser on my W6. It doesn’t start now. I backfired when I tried to start it. Any suggestions?
@DrRust
@DrRust Год назад
Did you take off the plug wires if not then I would make sure the points are set properly and open and close normally
@AndrewHCann
@AndrewHCann 2 года назад
Got going right also when low idle lupping don't hear got right and when got high idle sounds cold throat got right on money and cap with distributor adjustment should be 3:30 clock on min hand be like on watch or clock ! And want running low idle and mixture screws on just went sound mellow no hard hit missing sounds for low and high! idles !
Далее
How to Adjust the Carburetor on a Farmall H
13:05
Просмотров 21 тыс.
Самый БОЛЬШОЙ iPhone в МИРЕ!
00:52
Просмотров 900 тыс.
Farmall H Carburetor Struggles!
18:40
Просмотров 4,2 тыс.
Farmall 140 Carb Clean and Check.
12:26
Просмотров 1,3 тыс.
Buying Another Farmall H and Getting it Running.
17:58
Farmall M governor rebuild part 5
26:43
Просмотров 3 тыс.
CARBURETOR REBUILD TIPS DO'S DON'TS
12:25
Просмотров 162 тыс.
More Repairs to the 1940 Farmall H
21:39
Просмотров 37 тыс.
Farmall H & Farmall M: 5 Differences
9:26
Просмотров 91 тыс.