Fixing Frozen Water Line In GE Side-By-Side Fridge For Good And For Free

Подписаться 1,8 тыс.

Просмотров 42 тыс.

50% 1

Side-by-side fridges, particularly GE models (in my case the GSL25JFPA BS side-by-side refridgerator), have a longstanding history of frozen water lines so that nothing comes out of the dispenser. Reasons could be of electrical, mechanical, or other nature. And it is the "other" category that is the culprit: it is the lack of insulation of the inner freezer door panel that allows for the freezing.
In this video I show:
a) How to isolate and solve the problem with a couple of potholders and double-sided tape
b) That neither a repairman or some overpriced gadgets solve the problem permanently
This video is a deviation of what I usually do: review portable audio gear.
Please subscribe to this channel and ring the bell above for notifications.
Please visit our blog: www.audiorevie...
Join our Facebook Group: / audio. .
Instagram: / audioreviews
Twitter: / audioreviewso
RU-vid channel: / audioreviews
Donate to this channel: bit.ly/2ArC8kL
For inquiries, contact: www.audiorevie...

Кино

Опубликовано:

5 ноя 2020

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 52

@fredklintworth1114 17 дней назад

For six years, we had a plastic string in our GE refrigerator water dispenser. However, when we had to replace the freezer thermostat two days ago because of a defrost problem, the water started dispensing like new again. It has been two days since the replacement, and the water is still flowing well. I wanted to share this experience so that others can also consider this option for their refrigerator.

@lfenn1 3 месяца назад

I've been suffering from this problem for about a year now, thanks for the tip, I have been problem-free for the last 6 months

@moddie1309 Год назад

Same problem, same fridge. I had my doubts as to this simple fix and if it would work. However, your scientific method was convincing and I had nothing to lose. Not having a suitable pot holder, I used a 10x10 inch square of some foam core board (like kids would use at the science fair) and some "3M Exterior Attachment Tape, " just fancy double-sided tape I had left over from a car project. I opened the freezer, warmed the plastic to room temperature to remove condensation, attached the form core board, defrosted the line one last time using the warm water in a small tube technique and I'm THREE DAYS with a working water line. No reason to believe it won't continue working. If it does, I'll add another layer of foam core board! Thank you, sir.

@Ken-gv2ql 5 месяцев назад

Thanks for this tip. Our GE fridge water dispenser had been freezing occasionaly and then over the years freezing more and more until now when it freezes every hour or two. By adding the pot holder inside the door the problem went away immediayely. Genius! thanks again

@openmind1a 2 месяца назад

6-5-24 This DEF works!!!! 100%!!!!! Thanks a million! Was driving us mad!!!!

@johngg25 8 месяцев назад

Dr. Schweinzgruber ! I have the same “exact”refrigerator ! Same year. I did the insulation method you recommended on the inside of the black appliqué panel, using insulation from my furnace, and it has completely solved the problem. I am also an American engineer working at Bosch in the US. Your fix was great. I believe the problem only comes later in the life of the refrigerator, because the little bit of insulation that they put in that section, has completely shriveled up. Thus allowing too much cold transfer through the door too the waterline inside. Your method to add more insulation, allows the warmer kitchen air to be in better contact with the water line, under the nozzle area. Perfekt ! Danke ! Send me your email, and I’ll send you a picture of my patch work. 👍

@ducly3078 2 месяца назад

I have same fridge

@vasuchari5266 3 месяца назад

This worked perfectly. I used an old pot holder.

@billstrickmaker4769 Год назад

Absolutely Best Tip Ever! Thank you Dr. Schweinsgruber Cured my Problem So Fast! I used (Scotch 3M Permanent Double-Sided Tape - WALMART) comes in a dispenser like scotch tape. & 1/4" Aluminum Foil Insulation sold at Menard's . Project look's good too. Thanks Again!! GREAT TIP!

@benjaminsmith6041 Год назад

Used .095 weed Wacker plastic cord up the water dispenser , took several tries to get full 3-4 feet up fridge water line! Then it started working again after several days and a dozen other videos!!! Thank you. No one else suggested rotor rooting the line!

@audioreviews Год назад

But it is not a permanent fix, as the line will freeze again.

@fatmao7830 8 месяцев назад

Vielen Dank, Herr Doktor. Very helpful to me. Have been using a hair dryer every 4 or 5 days. Even turned off the ice maker but that did not help. Your solution works very well. Thank you again!

@Glenora56 7 месяцев назад

Thank you so much! This happens every winter and fixes itself in the spring. So sick of it. I used you method using boing water in a tall Yeti cup with towels and hot pot handle to hold the heat in. After 40 minutes it was fixed! Place the pot holder on the inside and so far so good . Great advice!

@AnneRoss-xq6gn Год назад

Thank you, Dr Schweinsgruber - a standard 7 1/2" square potholder did the trick! The water dispenser has been working for a full week now. Wish I'd seen this before bringing in a technician who recommended a new door for $2000.

@audioreviews Год назад

Haha, the new door would have not made a difference. In the meantime, my fridge died completely...

@John-m5r2c Месяц назад

I have a problem like yours. I’m definitely going to try it thanks for the advice 🙏💪

@florret2003 Год назад

Thanks for the tip. Instead of the pot holder, I cut a one inch thick piece of 8"X10" pink extruded foam with a hot wire cutter, covered it with some white film heat activated glue backing model airplane covering and attached it to the door with 3M trim double-sided tape.

@user-ii2ph5cf2b Год назад

Thank you, Dr Schweinsgruber ; This definitely resolves the issue , i used a piece cut to shape from a foil back type of windshield sun shade @$6 and a roll of gorilla glue double sided tape...it definitely looks to be a permanent fix... Next option i was planning; drill small hole and fill with spray insulation foam...

@darlchryst673 Год назад

Very helpful! Just telling me where on my door is the freezing problem so I could focus my blow dryer there was immeasurably useful! Thank-you for taking the time to post this.

@audioreviews Год назад

Thanks...the ridge has died completely since and was replaced :).

@Obelisco_11 Год назад

ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-e0oZkJKinPc.html

@frankjrcrumpton4320 Год назад

Pour hot water into your waterpik and it will clear the clogged ice within seconds.

@3rdyellow 5 месяцев назад

Our GE fridge's water line used to freeze every other day. Yes, unfreezing is easy with a small tube (or straw) with syringe attached and injecting warm water into the water line from the front, but still a hassle that has to be done many times during the week. What eventually worked for me was using a bubble wrap foil insulation which I used three layers of and taped all four sides with aluminum tape. Where this video shows the oven mitt (6:48), I covered the entire side and a bit more to the top with bubble foil insulation, in three layers, then taped all sides with aluminum tape. Water-line is frost-free for over a month now. I wish GE had properly insulated the fridge. I wonder how many bought new fridges because of this issue alone.

@raikauno 2 года назад

New subscribers here 👍.very helpful and it works.

@georgeromo3506 6 месяцев назад

Thank you sir for the advice and the quick fix. I have defrosted my freezer twice in the last week Yet the water line keeps freezing in a matter of hours.

@gmaki53 3 месяца назад

The root cause of our frequent freeze-up was the small solenoid that pulls the ice dispenser flap open had corrosion build-up which created friction that prevented the flaps spring from being able to snap the flap closed after ice had been dispensed. With the flap partially open, cold air leaks out near the water tube and made it freeze. It is easy to pop the control panel off, remove a few screws, remove solenoid and clean/lubricate it.

@liemnguyen5264 6 месяцев назад

Thanks for the "permanent fix". I put a pot holder as you said. Hope it works for me.

@tonyrodriguez2003 6 месяцев назад

Great information and video. Thank you very much (Danke).

@JoyoftheGardenandHome Год назад

Worth a try. Been blowdrying for months!

@user-ov4ir5hl5g 4 месяца назад

Had this exact problem. Hoping this will work but this is a wonderful video!

@dennispickering77 5 месяцев назад

fantastic and so thorough and methodical and logical and honest. wow. thanks.

@audioreviews 5 месяцев назад

Glad it was helpful!

@Obelisco_11 Год назад

In this region where the fabric was placed to insulate, there is a hidden resistance that is responsible for heating the door, it is to freeze in excess!

@Cipofan42 5 месяцев назад

Thanks so much. This has been frustrating for months!

@audioreviews 5 месяцев назад

You're welcome!

@lalvarez19620704 7 месяцев назад

Wow! We have been fighting thermodynamics and the physics that comes with it. Thank you - thank you for giving us the correct answer to this annoying problem which started very recently. I used a slightly different tact - I inserted 3 inch thick insulation into a zip-lock bag [the size of the area of concern] and attached it as you described to the inside of the door. Worked like a charm - PS I don't believe in charms. Only Jesus and His One Holy Catholic and Apostolic Church! Pax et Bonum! and thanks again!

@jameschains Год назад

Getto solutions, love it

@osajohnson1957 Год назад

Use a Silicone lubricant on the gasket. Vaseline (a petroleum product) will eventually destroy the rubber gasket - also a petroleum product.

@kevinhikes3132 Год назад

Smart man, shout out to all the plumbers

@catherinekovacs7569 3 месяца назад

I have the same problem; however, my ice machine is freezing, too and not producing ice. Does anyone have a remedy? I have the same model. Thank you.

@robertl1244 3 месяца назад

And, what is the reason my water dispenser is so slow. 12 ounce glass... 47 seconds. I hate it. Always done it. New filter and still! Don't know what else to do

@sunkmanitutankaowaci2733 Год назад

I like your repair, however due to the tape possibly not sticking I’m going to take the inside door panel off and insulate around the water line with refrigerant line insulation. Also I don’t know if u mentioned or if u knew but they sell an inline heater for GE refrigerators for less than $10. I have a Frigidaire unfortunately

@michaeljlink 7 месяцев назад

Would 1/4" insulation tape work?

@thecaptfun 7 месяцев назад

This worked great but right after I did it I also replaced the light bulb. I notice in your video that you do not have a light bulb installed. Could be the extra heat from the little light bulb keeps the line clear. Funniest thing? I keep our Sriracha in the same spot on the door!!

@audioreviews 7 месяцев назад

don't think so!