Flamma FS06 Preamp Walk Through 

There is no XRL input only one quarter inch input. However if you had an XRL to 1/4 inch converting transformer or another means of converting the XRL to 1/4 inch it would work then. Keep in mind it wasn’t made for vocals.

@@Warbrd Good boss so I can buy the cable, I wanted to take my doubt if with this 1/4 cable connected to the microphone the preamp works normally, because its cost is very good and I already bought it, but I only see review in guitar tests, more I want to test it on the microphone

It’s a good question. I gave that pedal away but if I get a chance to use it again, I’ll make a video with pre pedal effects into Flamma.

Yes, absolutely!

Chances are that you will experience some ground loop hum. If that's the case you will need to use a D.I. and lift the ground.

Yes I believe you would be able to do that. “Press the SAVE button and footswitch simultaneously to turn on/off the cabinet simulation. Press and hold the footswitch to change between the two modes.”

It might work great that way, but it is designed to replace your amps front end, not run through it (with cab sim off). Or go directly into a mixer (with cab sim on). Not really a distortion pedal replacement, but could be used that way.

@@Warbrd or directly into the fx loop return? (bypass amp's preamp)

@@wazootube it’s a good question I don’t know I’ve never tried that

It can drive an amp closer to breakup.

It's been a year and now i have the same question. in my opinion mooer preamp offers good control by using the footswitches only, allowing u to change between presets with ur foot and u can load IR to mooer preamp. but this flamma fs06 offers good value at its price