Great video!!! I just did my 19 with guidance from your well detailed video. Assistance with those clips would have been great haha. I had to go opposite for the orientation of the actual unit as my in out is opposite your 20 and my plugs are blue and green. But very easy to adjust. It almost felt like cheating with your help. Great work.
Hi. I like your video, it helped a lot when I did mine. I noticed that you said there was a seal that came with the filter 16:47, I believe that goes on the outside of the threaded part of the filter.
Good Clear instructions! too bad i found this video after i broke the little blue clip! I am having trouble unlocking my electrical connector! i know you said you used channel locks but I'm so afraid to break the plug! I am taking my time and have spayed the connector with some electrical connector cleaner hoping it loosens up! thanks for the video!
Thanks for the video. I just installed this on my truck. That blue clip was strange and I didn't know if it was released until I pulled on the line. Honestly the part I spent the most time on was reconnecting the electrical plug. It didn't want to latch for me.
I like your vid. I have an 18’. I didn’t burp mine and when I started it fuel shot everywhere. I opened the drain after I ran it for a while and fuel just dripped out of it. So not sure if it working properly or not 😂
I wonder if this system can get installed on my Lm2 as well , i mean either your truck and mine both use same filter cartridge soo.. and i know VSE has a newer model with 2 filters..
The issue with this is it puts the filter on the clean side and once you get the water in fuel message you are already sending it to your injectors damaging them.
@@FROGMAN524 my kit arrived wed. have you done anything with the crank case vent system? we have both done the same mods so far it looks like. mine has everything banks makes on it.
When you get water in your fuel, and draining the bowl everyday or twice a day, you’ll be happy you have a spin on filter. Way easier to drain. With stock you have to get a ratchet and soak your tools and hands. Spin on you can avoid most of that mess.
One more thing man, how low does the sensor sit in the new fuel filter system ? I’ve seen a different video where someone explain the sensor doesn’t sit low enough in those system to sense water in the filter therefore it is a better micron filter with a bad sensor position.. did u check on that ? What’s your take ?
@@Italianborn I have not heard that but it does sit a bit higher than before. I think if you get bad fuel with water in it, it will be more than just a tiny amount that would only fill up the bottom inch of the filter.
