I have blinking yellow light on gps switch. as you say it indoors at this time . I need to see if it change to green outside today.if it work I will not upgrade the gps unit.
I did exactly as you explain in this Video Clip (3D-»ATTI=1400) so it was expected that my FW450 would actually maintain the Altitude BUT THAT IS NOT HAPPENING. If I don't control the "altitude" with the Colectivo, the Heli will fall to the ground. Can my Friend give me an explanation for this? Thank you very much for your attention. Mario
Been trying this on mine but atti seems just like 3d to me as mine will drop if not fast enough on the left stick she doesn't stay at any hight but is spot on in gps
@CRUZROYHelicopters doing that right now lol. Seems to gain a bit of collective between gps and atti that normal ? It sure didn't climb last time between gps and atti gps is rock solid All looks good gonna try
Ok tried it again in just gps all is still good but I think I damaged the belt last time it came down fast I switched back and gave it up it made a unhappy noise I suspect a few belt teeth are gone
If it is dropping you are in 6G mode you have to go on the software and hit the factory reset button to completely reset the flight controller to get ATT mode especially if your H1 is the heli version but caution when you hit the factory reset make sure that you have either wrote down or took a screenshot of all your previous parameters and swash plate numbers before you hit that factory reset Hope that helps you
Now when you get done setting to factory default settings in 2.0 and you get all your parameters and everything reset when you get done have it in 3D mode which is the blue light if the tail motor does not start when you unlock it then you have to go to version one 1.81 and restart the tail motor in that version I know it's crazy but I've been through all this that's how you have to do it if your tail motor starts in 3D mode then you're fine
