Ford C6 Wide Ratio and Rollerized: Part 2 Detailed assembly

Подписаться 706

Просмотров 1,9 тыс.

50% 1

In this video, I show/demonstrate and talk about the detailed assembly of my wide ratio, rollerized C6. I explain all the clearances were achieved and what roller bearings were used. Spoiler alert: at the end of the video, I found that I had NOT cleaned my pump🤦🏼‍♂️ so I did stop the video to clean it. Therefore, you never really see the final assembly of the front pump into the transmission but based upon all the dry assembly that I did, everything discussed in here gets you a ready to run fully rollerized, wide ratio C6

Опубликовано:

30 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 8

@0lddragracer426 Год назад

I have a 94' C6 behind my big block Ford engine. I'd like to roller-ize mine also, but that looks like a LOT of work. I'll probably just go with the partial rolleri-ize. I'm sure you're going to pick up some HP at the rear wheels for your efforts. The C6 is noted for an approximate 50 HP loss because of the washers instead of bearings. You explained everything very well, and the breakdown on manuals and parts was helpful. I sure appreciate that, thanks. It's hard to find anything anymore on the C6 Transmissions. After you get it running, I hope you make a video and let us all know how it works. I'd really like to see that.

@johnjaniak473 Год назад

Thanks so much for taking the time to show that process, got a better understanding what goes on in there

@ob1n Год назад

Glad it was helpful!

@adriannanavarro1032 9 месяцев назад

Hi I recently bought a ford mustang 1970 with a leak in the transmission. We changed the oil filter, cleaned the oil pan, and installed a new gasket. It kept leaking so we bought a new gasket and it still leaks, any answers as to why?

@ob1n 9 месяцев назад

Depends on where it's leaking. Transmissions can leak in many ways. You have to get underneath to pinpoint the exact area. Check for the dipstick tube, shifter linkages, torque converter area, etc. Hope this helps

@427_FE Год назад

Good job on the video, I know I'm late here, but the mod you did at 22:40 in is genius ! I did the Gear Vendors O D on my C6, and it was worth the money, thanks again !

@ob1n Год назад

Thanks! Very glad that you got some value from the video