Thank you. It's pretty much just pulling the 20 amp fuse out of spot 48, putting in the fuse tap with the 20 amp and 5 amp. Super simple once you have the kit in your hands or if you watch the unboxing video of it. Everything is plug and play other than the ground.
@@IntellibeamGreat Video!…question…my emblem came with the hole for the camera….but also came with a “plug” for the washer. I only have the camera….an I supposed to just glue the plug over the washer hole? I ordered “with camera/without washer”.
@baila4buddy17 double check to ensure you used both fuses in the block they give you to plug into yhe fuse block. The one part missing is how to arrange the fuses. It took me a few to get it right. Use the one the provide on top and the one you pulled out on the bottom.
@@lucasmurray9697 Again, thank you so much for taking the time to post a solution. I plugged in the other fuse and it worked! Yay. You made my day @lucasmurray9697. I hope you have a fabulous day.
just finished with the installation. it was very easy to follow. i use the 48 slot as you mention. my only problem is that when i unlock the doors like you did. the ford logo stays off. it only turns on when the truck is running. remote start or physically push start it. please help.
Sweet job bro, looks choice! But it might be nice to go into a headlight or parking circuit, so that when leaving truck on for hours such as camping or job site, then wouldn’t have a bright light lit, as turn off lights then.
@@Intellibeam got mine installed was able to take some shortcuts as far as pulling apart headliners in the hood. However using fuse 181 I've noticed the truck stays on for more like 20 minutes after you turn it off. In addition it's on the entire time the truck is charging. Going to try fuse 48
thanks for the video, but 1 question, couldn't you just connect the positive and negative emblem LED wires to the positive and negative power wires that power the front LED bard instead (like you have on yours already?)
I just did mine but the emblem won't sit quite flush on the bottom, there's a small gap by the camera. Did you have this problem? Everything else went fine
