A quick example to show how two XACT servos are programmed by FBUS to :
CH2 for Elevator
CH4 for Rudder
First I have programmed the TD R18 to have FBUS on Pin18 by way of [RF System] - [Set] - [Options]
The servos are connected individually and programmed with different Physical ID and Application ID and the channel set to the corresponding channel. Click 'Save to Flash' to set the servo settings permanently.
Then the servos are connected by a Y-cable to the same Pin18 and are able to operate independently on their assigned channels.
This allows for simple wiring connection by way of Y-cables to connect the [Elevator + Rudder], [Left Aileron + Left Flap] and [Right Aileron + Right Flap] to simplify the wire management.
Note: At 1:47 I say "Aileron" but I meant "Elevator"
14 окт 2024