Awesome! Always wondered why my steering freaked out when when I flipped my Gen8 over to work on something and it was on. Never knew it had a gyro in it. Have to turn that setting off for this model. I will DEFINITELY be keeping it on for my Shumacher Procat K1 though... that thing is so squirrely unless you eeeeeaaassseee on the throttle.
hello, back again😂 i was reading your comment again, the last sentences there, what you should do is at the svc setting keep that on, scroll down look for throttle gain, set that on and go to something like 70% and try taking off full send, what it does it that it cuts back throttle when the vehicle gets sidesway and regain throttle once it straithens(i fuked that word up😂) out. lower that number and try again until u can control the squirry fishtailing. ALSO, Priority: set it to on and keep it on a low %#, the gyro will keep that car,,,,,,,, mmmm, think of it as if its making the car run understeered, so the faster you go the less steering the reciever will do even if u steer the controller all the way, the gyro will prevent a spinouts. so the slower u go the closer the steering circle will be. the faster u go the larger the steering circle will be. this is usefull when going from 10mph to full speed pass, circuit racing.
I need help with mines I’m running a castle momba monster x 8s and TP motor and on the controller it says it don’t accept it. Meaning I can’t use with with this setup I’m not sure what’s going on I have a power HD brushless high voltage servo
so your controller, the radio transmitter says that? i have never seen anything like that before happen. my boys they run that setup mm8s with tp motor for their speed runs they insane.
For some odd reason my car keeps going to left a little I tried everything to get it to go streight do you have Instagram I can maybe share you what’s happening cause I definitely need some help
