Hi, thanks a lot for your movie. I have one FS-i6 to 10CH but for some reason no manual was attached to it. Your instructions are clear! Thanks again for help.
All this transmitter crap video that is in the you tube, yours worth of a million, seriously Flysky should pay you for this awesome presentation. Like Kunal said: I can go and buy the fs i6. thank you for the video. keep it real my friend.
I think only you make video how to upgrade firmware and bind with 10ch rx then try the channel one by one.. It's great and clear video i've seen..thanks😃🖒
Thankyou for this. Your channel is very helpful. After the firmware upgrade, besides the increase in no of channels, were there other useful enhancements ? Any disadvantages ?
The video claims to show how to upgrade 6 to 10 channels. However, you start off with 10 channel. How exactly does this explain how to make the upgrade? If you change the title it would be a good video.
Hi! I upgrade my transmitter and it binds with the fs-ia10b reciever but when I put a servo to test nothing happens...at any channel. I have set up the auxillairy channels and the failsafe. Thank you for your support.
my flysky transmitter looses signal and gets unbind bought a new reciver then too had the same problem please help sir from were to buy the USB cable to upgrade firmware to make it 10 channel
I want to make a flying wing so I buy a flysky CT6B I I don't know how to set up 2 position flapserons please up load a video Sir it may request have a nice day sir
100% Yes, My all FPV flights are with iA6 and iA6B ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-GFye30SoJe8.html ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-3s2bG8JP888.html Both flights are approx 1 Km range
Sir how can I get a radio like this ,I need it for my project at school am from Nigeria, I need your response, sir I need your help to get this GOD bless sir as response.
Bro please check the description of the video, there you will get a step by step video's link and the link of Firmware which I have used is also in the description.
MakerHand I tried back to default firmware but it doesn't work either..or my way to roll back wrong? Which Exe should I use in all the file? Thx for reply me
The first 3 days with the remote control I could not drive backwards, it cost me a lot of nerves, until that worked. And i dont know exactly what ive done lol If I read the comment sections of the i6 remote control videos in connection with rc cars, I was probably not the only one ^^
you need to connect the ESC to the channel 2 because in channel 2, the stick stay at the middle position(1500) in car esc 1500 is stop below 1500 is backward above 1500 is forward
There is link in the description, where you'll see how to do that. And if you want the proper 10Ch firmware then contact me I'll send you the proper 10Ch firmware.