Dude, are you a teacher by profession? Your's was the most concise tutorial I have come across in the last, I don't know how long, maybe a yr or more, that actually delivers. Someone stops to ask for directions, "follow me" you say, low and behold they ended up exactly where they wanted to go. No detours along the scenic route of the entire fuel and electrical system, generic of course, as in a schematic that is written in electrical gibberish of letters, numbers and an occasional minus sign or squiggly characters that only a trained electrician could understand. Then they drove off, waving goodbye and the tourist is hopelessly lost. The minute your video started, I immediately recognized the bracket for the wiring harness and held my breath. Were my expectations too high in wanting a general walk-through of how Honda's are put together? Not this time. Thank you!
@@jesushimself2583 you need a pick or a tiny screwdriver, there should be metal clips kinda like a paper clip on the left and right side of the plastic housing, Start at the center and pull the tip of the clips outwards they hold on to each other at a right angle
Could bad fuel injector cause no start ? My Civic will only start if I press the gas pedal then it dies when I let go off the gas pedal… I have code P0303
could be idle air control valve, chech it first. Then check spark plugs, cables, distributor. One of the cylinders, may be more, might not be firing. Check them first. If these are fine, check compression. 2 cylinders are enough to at least keep the engine running for d series or b series engines. I dont think your problem is from injectors, odds are too low for all of them to go bad at the same time.
