General Electric Washing Machine Not Starting - The Motor

Подписаться 54 тыс.

Просмотров 134 тыс.

50% 1

General Electric Washing Machine Not Starting - The Motor
Replacement parts amzn.to/3SSBGld - paypal.me/Angeltheapplianceman
Warning: Use the information in this video at your own risk

Хобби

Опубликовано:

1 ноя 2011

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 27

@matthewspilotros2148 Год назад

Great Video! Step by Step details and easy to understand. Good Job, I appreciate your help in this video!

@calmdown7452 2 года назад

Very well done.

@bobsoft Год назад

Where is the capacitor for the original motor that was changed out as bad? Do those motors have their start/run capacitor internally?

@kelvinharris6313 3 года назад

Very good

@muhammadadil9373 2 года назад

I have a kenmore washer which runs for around 10 seconds and then trips. I noticed that the power cord gets hot. It spins when I need to drain the water and drains very well. Any idea?

@atxjax1 5 лет назад

Which wires to check for ground fault? I have a washer that trips my GFCI circuit but when plugged into a regular non gfci circuit it runs fine.

@theapplianceman 5 лет назад

Sorry I don't know

@mariojimenez4993 3 месяца назад

Por favor en Español

@kelvinharris6313 3 года назад

I jump the door switch but it just fill an drain

@muhammadadil9373 2 года назад

I have a kenmore washer which runs for around 10 seconds and then trips. I noticed that the power cord gets hot. It spins when I need to drain the water and drains very well. Any idea?

@TheeMissingLinc 5 лет назад

Do you know how to test a different GE top load washer motor? I have 5 wires, orange, red, yellow, black, blue. it looks to be a pretty common motor

@theapplianceman 5 лет назад

Sorry my friend i don't have that information

@kevinkevin9448 6 лет назад

How do I check get top loader washer motor for power ????model wjrr4170g1ww ,,,.I jumped door switch and pressurized the pressure switch and still nothing ???any help please

@tmiller1916 11 лет назад

My schematic has a capacitor at M7, and unless it is included in the test circuit the motor will not start and the test cable will not work.

@ScantPear 5 лет назад

Do a full cycle on your washers

@jjrock5 5 лет назад

Do these instructions apply to the GE hydrowave washers? The wire colors don’t match. Thanks

@theapplianceman 5 лет назад

No, the hydrowave washer is a different kind of washer

@jjrock5 5 лет назад

theapplianceman is it difficult to test the motor directly? I can’t seem to get my washer spin or agitate. Green light blinks 1 sec on and off (no codes), Lid switch tests ok via continuity test, no codes in service mode at the control panel, fusible link not blown, shifter coil tests ok via resistance, I replaced the motor with a known good used one, I checked for 120VAC at the motor side harness and that checks ok. I think I checked everything and it still does not work.

@jjrock5 5 лет назад

I also did a motor reset via lid opening and closing and nothing.

@theapplianceman 5 лет назад

These machine are a piece of garbage You cant even try the motor like a regular dryer. I am sorry but I don't have much on that type of washer.

@theapplianceman 5 лет назад

Check this link on youtube to see if there is something that mya help you. ru-vid.com?search_query=DBVH512GF1ww angel

@habibullah2000 11 лет назад

I have wsm2700dawww spacemaker washer and dryer and i need to connect it directly with 120 volt ac which wire i should connect to have agitate mode and spin mode. Help plz

@theapplianceman 11 лет назад

Sorry I don't know anything about the spacemaker