I mean.. the overall concept of the end product is good, but for this to be profitable you need to make make changes to the mold such as: putting hinges on three corners of the mold and a latch on the forth for easier release and reassembling for next part and secondly... a bottom plate beneath the one with cut outs that the inner blocks are all connected to so all inner blocks are all pulled out evenly and together, this will speed up your cycle time for how fast and efficiently you can produce pieces.
Salem.tres beau claustra bien fait mais fastidieux (long a réaliser) si les planches du cadre étaient bien lisses ( peinture à l'huile par exemple) tu peux enlever le contre plaqué du bas et soulever tout le reste sans avoir a dévisser le cadre. Idée géniale bon courage.
Untuk desigennya mantap cuma agak terlalulama dibuat 1 buah udah berapa menit, nantinya pesanan Ratusan buah ..Wah Lama Banget, broo cari solusi desigen cetakanya supaya lebih Praktis, jangan jadi Praktisi..kwkwk😁 salam..Mantap....
Shouldn't be using electric machines, putting timber over a planer is total stupidity, I've worked with men that lost fingers when the wood slipped Because they never used the fence that comes with all planers, it does'nt make you a better tradesman by being irresponsible, i hope your not teaching for a living. plus the gaurd on a saw is also to stop the timber from lifting and flying back to your fizhog.
End result is good but ypur method is pathetic. R u telling me that for each time i gotta screw in and then screww out someting like 20 screws??? Forget it pal. I gotta a much better method - go to my local supplier.
Muy bonito y todo, pero la vida tiene que simplificarse. Ese artilugio seria muy complicado de ponerse en práctica a la hora de querer producir en masa
Whata pathetic idea. U make 1 after all that screwing & what not then u unscrew the whole damn thing & then u make 1 more than u unscrew the whole thing again. How pathetic. Remind me not to watch this dude again.
