On my 139qmb engine crank goes in easily with hands and it ends up moving side to side about 0.3mm. I mean bearing get to move axially i their housings (cases). Is that normal for GY6? Should it be so tight in case that it could not move at all? Bearing are in good shape, but should i still buy new ones with bigger OD tolerance? But if istalled tightly, should bearings then sit in bottom of cases? If so, then maybe shims should be added between bearing and crank webs?
I was going to put a 80cc motor in a 50cc scooter. The hole in the crankcase was small so I took a grinder to make it bigger but I decided to go with the small motor. The point is, can I wash the shavings out of the crankcase without taking it apart?
Wouldn't case wear cause that crankshaft to move out of position slightly causing the rod bearing to wear and creating the same problem, when the rod bearing wears it drops metel shavings into the oil, I think a $329.00 Amazon or Ebay engine would be better.
I BROKE MY CLUTCH,REPLACED IT.I TOOK MY SPARK PLUG OUT,TO CHECK IT OUT, IT WAS SMASH ON THE END? WHAT WOULD CAUSE THIS? NEED HELP!!! THANKS FOR ANY INPUT!!!
I have a trailmaster 150 xrs go cart im replacing the crank i ordered one and it has the same size bearings on both sides of the crank the one i pulled out has a bigger bearing one the clutch side did i get the wrong crank or do i have to press on a new bearing
Thank you for the video. I'm trying to fix my Vespa 50cc because of horrible noise and power lacking. Need to replace bearings. Can someone tell me what specific tools do I need that I can't find in a regular store? Thanks a lot!
Hello could you please tell me how to get the kick start gear off from the other side when taking the old crankshaft out? the 1 thats under the variator + before the oil seal, cheers
This motor did not have the gear because it is out of a trike and does not have a kick starter. Gear removal simply requires a gear puller, they can be stubborn.
Dude, you've got a terrible hum in your mic. Are you using an external microphone? I can't pay attention to what you're doing or saying for the racket. Rerecord your vids and watch them yourself before posting any more.