Hi How are you I assembled everything but the sensor showing me less than 20% I tried everywhere it doesn't help. what can i do ? I will appreciate your help
Can you share your setup? RPM setup, sensor setup, cut-off setup and where exactly did you install the sensor? I`ve been trying to set mine up over a year, but I think my healtech does`t work well. My sensor values varies between 20 and 30% while I am shifting gears, too low in my opinion since the minumium adjust is 20%. I don`t have another kit to compare. My current setup works smoothly like the original one but for many times suddenly starts to work rough under the same setup in the same ride while I am shifting gears. Sometimes work rough most of the time, but if I turn my bike off and turn on again to reset it, this is back to work well again. I would say 75, 80% of time works well. I am trying to figure out what changes when shifting gears are bad. If is the sensor delay change, or cut-off time change in its hardware. I tried to change how strong I kick it, how fast I kick it, but nothing change. I changed sensor position to nearest to my foot and I didn't have any significant change.
Hey Bud, I have 2 bikes and the set up is different on both. It all depends on your original set up. You are welcome to give me a call to go over it. Also, it’s never 100% smooth not even on the factory model. They do have a sweet spot where they were best.
@@moearmani7884 I’m doing good bruh , ok Got it . I was washing Moore mafia do a tune on a Yamaha R1 S and he installed Dyno jet Quick shifter with Clutchless up and down.
@@moearmani7884 can you tell me what your settings are? Because you wrote You can cause damage if you don't know. I follow you and love the videos you upload I also ordered ignition coils
I appreciate you. It’s more involved to type it down for you. Feel free to call me at 949-689-6199. I will give you multiple pointers to avoid damaging your transmission.