Love the build. The wing stripes are sharp. Where did you get the Hatch Scoop? I am assuming it is 3d printed. Do you mind sharing the link to the file or where you bought it? Thanks!
I can't wait to be able to order one. I'm definitely going to be ordering a set of servos, I was going to use a Maytek F411 wse f hope that it will fit ? Thanks again for the video and information
Mine is flying with the H743 from day one, on 3 2700 lion from day one on DJI system, and crossfire protocol, and is just perfect. The whole system is compatible. Using Inav 4.X.X
Would be nice to see an upgraded canopy clip. I have installed some magnets on mine to back it up. Im reasonably impressed with mine so far however the servos are not the best looking tbh i was tempted to change them out for something a bit more durable. Managed to squeeze in 3s 4200 21700’s, full sized dji air unit, F765wse, pan cam and xfire. So given its so small is can carry the kit
@@Painless360 i have personally yet to have a problem but have seen a couple complain now where the clip does not grip as hard over time. But i have not used mine enough to have any issues yet. Have you tried diff thrust yet? If so how is the behaviour?
@@Painless360 i have seen a couple of people report canopy falling off and looking at the design it could certainly be improved. Weather its been fitted badly or it has indeed failed either way its a “mod” or “improvement” that would be more use than a carbon boom. Also 20 years a heli pilot back in the day of my Xcell fury and love the bling but also always looking to improve things
Thanks Lee. I’ll be ordering one of these. Do you have a recent inav build series for basic airplane like this one or the ZOHD Drift? I learned everything about wings from your videos, now I’m building an airplane. Lol
Can i ask what voltage you are using on your new LED driver board? On the website the picture shows 5 volt input but the instructions state the operating voltage as 4-12volt?