Many must know in the early 60’s I help my dad just like many here tear apart cat dozers..sometime hydraulic-cylinders and other times the final drive on one side or the other.. I am from USA..I learn to work and I learned how things worked..Like any skill building confidence is very important for young people.. Nice work here all. It’s great to see. Hugs to the your youth helping here..
They didn’t forget, they probably just weren’t told to do it, I work with a lot of Indian and Pakistani people in Abu Dhabi and they are not prone to going the extra mile. They will usually do the bare minimum to look like they are working or completing a job or only specifically what they’re told to do.
Was hoping to see that they'd pull the Swing Motor and change that gear(not sure it get replaced without removing it). But looks like it didn't....until it makes a very bad noise again.
That looks like an expensive gear! I'm somewhat surprised that they didn't try repairing it by welding and grinding. Also was that water sitting inside the gear? Is there some missing drain or O-ring?
Mengganti swing GEAR kerja yang sangat berat.tapi masih d bantu dengan cren.tidak seperti yang saya buat,cuman bantuan 4 biji dongkrak.salam dari Riau Indonesia.
and yet itll still work without any issues... for godsakes it's a 7 inch thick swing bearing you salty, you were told a single dust speck gets in their and theyll be "catastrophic failure" lmfao privileged shit lmao btw you guys did great, just only thing is please be very cautious when going under the machine while it's in the air, on its arm. love from Canada 🇨🇦
Very funny Iam amazed in what the kid is doing and the kid is amazed in what the camera is doing or what the camera job is !!!!!they must be proud in what they do they are very talented people nothing is impossible!!!!!!!why no change the other piece too well nobody ask me. about safety🤫
Никакой воды не должно быть, там ведро солидола должно размазываться.... Без смазки один зуб начал крошиться и за ним дальше- больше. Причину появления воды нужно устранить....
Till two times "ouh" during tightening. They got three workers - small, medium and big and three pipes they put on wrenches, so they can get many settings 🤣🤣🤣
I understand those guys have little to work with but why do they struggle to remove and replace the slew ring when they could've used another excavator to lift out the old one and set in the new?
swing bearing is the proper term. basically a stationary sprocket mounted to the track frame, which the swing motor sprocket rides that big sprocket and rotates the top piece aka house. ps called a swing bearing because it's essentially a bearing with ball bearings all around that gear.
Culture of their work is more than terryfing! All done with flat wrenches. If they buy pneumatic one, job would be faster and could be done by three not by sevem or how many there were. Obligatory add sand to brand new element. Ant in the moments where more people needed work only one or two... I am surpised that they didn't weld it. But what with worn and broken gear? It will destroy new element really fast.
When SHTF these people will do ok.America on the other hand will be desparate to find someone that knows what they are doing.Key boards just don't get it done.
@@__-aleks-__ Неправильный! Этих детей порабощают, эксплуатируют, они будут обречены на жизнь в нищете и нищете. Только такой отсталый народ, как русский, мог считать это нормальным.
