Honda Fourtrax 300 front wheel bearing install 

Thanks and Thanks for watching.

I was thinking that the two-wheel drive model had a spacer between the bearing and the nut. If your spacer is installed yes the nut should be tight to it.

@@FourwheelerDoctor there is a spacer in there. Someone had worked on it and didn't tighten the axle nut all the way down. But I was putting a new wheel hub on yesterday and I put the spacer on the rim o had taken off when some people came around, and one of them lost the spacer. I used a bearing brace or race (not sure what it is called) because it was about the same size as the spacer. I would buy new ones, but I can't find them online and I'm not sure what the exact name would be to look for. Thank you for you help. If you by chance know what I should be looking go purchase, please let me know.

Noni don't right now but I have one coming within the next couple weeks

I'm assuming in front. And is it a two-wheel drive model or four wheel drive model?

On the 2 wheel drive model, the tire should not turn when loosening the axle nut.

@@FourwheelerDoctor I have the 4wd

The bearings are pre loaded

MINSTAR Wheel Bearing Fits For... www.amazon.com/dp/B096W3J3C7?ref=ppx_pop_mob_ap_share

That’s where I got mine

Do you have a 2 or 4 wheel drive model?

Where did you buy the bearings? Do you have part #? I have the same 4 wheeler 4 wheel drive.