Great animation! I wish I could have this skills. It is not clearly shown how the pistol let the same amount of gas flowing for every compression of the trigger. 💪🏼💪🏼 Great job
It probably costs between $20-$50 dollars. That looks a single shot gun .17 caliber. The power of the gun, can b GREATLY Increased, just by boring out the long internal gun firing shaft, from end 2 end evenly, so as to be 1/4 inch internal diameter of the internal gun firing shaft, but still use .17 caliber bullets, & the gun will be a fatal weapon, b cüZzZ the bullet isnt impeaded as its fired, & the speed of the bullet will reach speeds of 1,000-2,000 f.p.s.(feet per second) terminal velocity. Any machine shop with a good table top drill can dü this using long Carbide drill bits & either used motor oil, or water soluble machine shop oil, when drillings out the shaft using a long 1/4 inch bit, the length of the internal shaft of the gun.
I wanna try to like make a shotgun shell with like monkey noodle bits I can make with like co2 which will like blast a hundredof tiny monkey noodles through a light amount of tape that keeps it in the shell but I’m not an engineer so I have no clue how that would work
J ai un pb de cp1 m. La cartouche est bien percée. La détente fonctionne aussi mais la pression de co2 ne se transmet pas au plomb. Quelqu'un peut m aider?