Тёмный

How to build a Chris Craft 283 / 350 conversion marine motor Part 3 

DonbAyers
Подписаться 1,4 тыс.
Просмотров 746
50% 1

Hello fellow Classic Boaters. In this Part we'll get the pan fully installed and mention the remote oil filter unit. Correction!! This is a 1967-1985 GM block as advertised by Michigan Motorz. Link below.
Thanks for watching
www.michiganmotorz.com/5-7l-3...
www.chris-craft-parts.net

Авто/Мото

Опубликовано:

 

19 дек 2021

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 7   
@GLF-Video
@GLF-Video 2 года назад
I’m excited about this series. I have a similar project. Thanks for sharing!
@DonbAyers
@DonbAyers 2 года назад
That’s great. If you can provide some details on your project I’ll try and incorporate some information for you as I go. Thanks for the comment
@DonbAyers
@DonbAyers 2 года назад
Is your CC build a manual box or a hydraulic?
@DonbAyers
@DonbAyers 2 года назад
I misspoke in the video. It's a 1967-85 block with two-piece rear main seal
@josephharmon5686
@josephharmon5686 Год назад
Did you have any issues with clearance between your flywheel side connecting rods and the oil sump line hose?
@DonbAyers
@DonbAyers Год назад
No clearance issues at all
@josephharmon5686
@josephharmon5686 Год назад
I found my issue, going from 283 to 305, I had to adjust the angle the hose fitting was coming out of the pump itself, not sure why it wasn’t the right angle but I pointed it like yours is and that fixed it. Thanks for the great videos!
Далее
We will see who will do it better 😂
00:14
Просмотров 2 млн
Rescue repair: replace broken rear axle shaft
23:42
Просмотров 10 тыс.
IMPSHI II | Van Dam Custom Boats | Part I
1:19
Просмотров 17 тыс.
Miss Canada IV Start Up
1:26
Просмотров 381 тыс.
New oil pan...and it fits!!!
5:32
Просмотров 38
Вложил 500К? Велокурьер?
0:53
Просмотров 865 тыс.