How to change front ABS sensor on HONDA CIVIC 8 [TUTORIAL AUTODOC] 

It's hard if the sensor breaks like in the video. If it didn't seize, it would be just pulling it from it's location

We have a playlist with the videos you need. You can watch it by clicking the link: ru-vid.com/group/PLWep5LzT0sxmINQqfypFTeY2HZ81-RUsv

The sensor body is made of plastic, there is a copper winding inside, but you can drill it out.

It is necessary to clear fault codes using diagnostic equipment.

After replacing Drive side wheel bearing and ABS sensor by my mechanic, I get on and off ABS VSA and Power steering messages on my dashboard. My mechanic says sometime it can take couple of weeks for a computer to reconfigure after installation of a new sensor. It’s almost one week but it has yet gone. Do you think this is bc of the ABS sensor which I had bought from Part Source?

The tightening torque is 185 Nm

We cannot tell you for sure. You can find this information in the technical documentation for repairing your car.

It’s difficult to say anything without proper diagnostics so that we highly recommend you use a professional car workshop to have a close look into the issue with your car and locate the faulty part. AUTODOC

The sensor was lubricated so that it would not stick in the future during operation, and if necessary, you can easily remove it.