How to change the turbocharger on Toyota RAV4 2l diesel

Подписаться 2 тыс.

Просмотров 56 тыс.

50% 1

#ToyotaRAV4 #turbocharger #mechanical #diesel #Toyota #workshop
Something 'bout July (Instrumental) by RYYZN
/ ryyzn
Creative Commons - Attribution 3.0 Unported - CC BY 3.0
Free Download / Stream: bit.ly/-_something-bout-july
Music promoted by Audio Library • Something 'bout July (...

Опубликовано:

16 мар 2021

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 21

@nginmumbetse7894 Год назад

Now then.. you didn't tell us about the bit between 1.30 and 1.31 did you? Nevermind, golden video, many thanks :-)

@marcinstachursk83 5 месяцев назад

There is many more bolts that is shown in video

@fizaraja2205 2 года назад

Brilliant

@almotawssitte7832 2 года назад

Thank you very much for this video and precision.

@strongdiesel7912 2 года назад

Glad it was helpful!

@frontsidegrinder6858 Год назад

Doing that change right now

@senadinmalkoc1254 4 месяца назад

Thank you very much how many houers you need to to this?

@papastash Год назад

Were in the video have u taken the 3 or 4 nurts off facing upward

@nigelsilk2336 11 месяцев назад

how difficult is it getting to the oil pipe ?

@papirs 9 месяцев назад

Can you help with some advice, I have a strange sound coming from the engine air filter box. My car Rav4 III, 2.2D, 2007.

@johnnydutoit 3 года назад

Hi StrongDiesel. Thanks for making this video. Could you comment on whether this would be possible without a lift? What level of access is required from underneath the car...? Thanks

@strongdiesel7912 3 года назад

Hello! Yes is possible,you don't need a lift however you need a jack to unscrew 2 bolts from the exhaust pipe. P.S. make sure you secured you car good before gooing under it

@lawrencefirulescu275 2 года назад

Hi StrongDiesel. How did you take out the third nut (the bottom one) holding the cat to the turbo?

@strongdiesel7912 2 года назад

hi mate use a socket wrench for the bottom nut and use a pry bar if the nut is too tight

@nginmumbetse7894 Год назад

@@strongdiesel7912 yes we used a 1/4" 12mm socket on a little 1/4" tommy bar. It's a fiddle! But possible.

@andrewmorgan5933 7 месяцев назад

Yes, just done my Turbo now. Luckily I have a 2 post lift. That bottom nut was really tight but just managed to get a 1/4 socket on it, a friendly tap later and away she went. Whatever you use just make sure its a hex socket or spanner. Everything else was ok.@@nginmumbetse7894