How to clean Wagner paint sprayer - control pro 350 

👍

You’re welcome 👍

You’re very welcome 👍

👍

hey Wagner what cleaning solution do you use to clean the unit after using enamel paint?

You’re very welcome 👍

All the best for 2021 keep up with the videos my friend 👍🏻👍🏻🇬🇧

I'm about to buy the skid one What did you think of it

@@grantmills1886 hey mate, it works fine, the taller one is probably easier to feed the hose into the paint tin, but I just use a milk crate to lift it up

This is not how its done... takes to long... probably is first machine

👍

Wagner has awesome products, their flexio range is also good. Each product has its place , hopefully not too long and I’ll have the smaller control pro 150 To test out 👍

@@billshowto looking forward to that and any other pointers you can give in regards to accessories. Cheers mate

👍👍

👍

👍

They are expensive 45 quid from screwfix I'm thinking of getting a graco tip holder and then you can use graco tips there a bit cheeper

Yes spirits

Did you buy a machine.. how's that working out for you

5 👍

With this sprayer there is no need to dilute 👍

If you wrap it all up in plastic it will be fine for a day or so. If it hasn’t been wrapped I would clean it all out and hope it hasn’t dried out👍

@@billshowto thanks bill. My first go on the machine today its like getting your first bike for christmas

It’s recommended, I haven’t done so yet though to be honest.

This is definitely recommended if you're puting it into storage for any decent amount of time! If painting regularly then it is less of an issue.

@@WagnerAustralia what is the recommended product and how do we actually prime the machine with oil/pump guard

​@@beaniebrotha Wagner sells two products suitable for this: 'All Guard' which comes in a 1L bottle, and 'Easy Clean' which is 125mL. (The small bottle is good for about 2 uses). Directions for use: Once you've cleaned up your sprayer, and the water is looking clear, you want to add a bit of the All Guard / Easy Clean to ~1L of clean water. Add enough for the water to change to a nice green colour. To cycle this through your sprayer, place the suction hose into the water/solution mix, and (with the pump set to the 'prime' position), turn up the pressure so it begins to circulate through the pump. Once that is done, we'd recommend switching it over to 'spray', and just spraying a small amount out through the gun (so it's internals are coated too). Finally, release the pressure from the system (by turning the pressure down, switching to prime, and pulling the trigger again), and your sprayer can now be stored away with the solution inside the system. Let us know if any of the above isn't clear.

@@WagnerAustralia do you store the hose with water in it or drain it completely and blow the hose through with your mouth or something?) thank you, Antob

Definitely uses more paint but so much easier and faster 👍

That’s what I want to know before I do it. I might ring Wagner and see what they say.

Wondering the same thing ... will require quite a lot of it!?

Drop sheets 👍

@@billshowto thanks.