Doesn't VONETS DEVICE support the Linux System? For Linux system, it needs to change the setting of the Speed&Duplex. Steps1: Login in the setting page---->LAN Setting ----> Ethernet port---> Speed&Duplex, choose the (100Mbps/full Duplex)
How can I watch the video while configuring the device? To configure the device I need to disconnect from the Internet and connect to the device, so the video will stop.
When the VAP11G-300 doesn't work for some device, please change the "Transmission mode" setting to (MAC layer transparent) STEPS: scan hotspots--->choose wifi hotspots--->next---->Transmission mode(Mac layer transparent)
Hi, after you power on the item, and connect it as video. You still can not find the page. Try to reset the item first and try again. Any questions, you can contact the suport: support@vonets.com
Power on the device, after 60 seconds, long press Reset button until 5 seconds, the green light will flash, then the device will automatically reset to the factory default parameters (it will take about 80 seconds to reset the device), please keep the power on during the time of recovery to factory default.
I have tried several times to configure the device. I am able to access my wifi network and enter the wifi password. After this I am able to "Apply" the settings but every time I "Reboot", it never reboots successfully. How can I correct this problem?
Hi, after configuring source wifi hotspot. Device is working fine! However I cannot access the configuration page (vonets.cfg) anymore. How can I access it again if I need to change settings?