How to Estimate the Amount of Material Needed For Your Shingle Roof

Подписаться 63 тыс.

Просмотров 18 тыс.

50% 1

This video will sho you how to estimate the amount of materials you will need for your shingle roof.
Go now to www.RoofingIntelligence.com to get the entire multi-part video series with all the information you'll need to install a shingle roof yourself. This video series is available to stream immediately online or to purchase as a DVD.
Chris Lutz is a professional roofer in Georgia and created RoofingIntelligence.com to teach people how to install a new roof themselves or to improve as a professional installer.

Опубликовано:

6 мар 2023

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 13

@PhenomenalDetails209 5 месяцев назад

Best video on explanation.

@user-bh1ox9wr7q 5 месяцев назад

This was very helpful, thank you

@slydog7131 2 месяца назад

Good video. Roofing contractors seem to figure on 25-30% field shingle waste and charge for that amount. On a 12 square roof I asked why the estimate was for 16 squares. Got no answer.

@KavinSBS 3 месяца назад

Good video

@angelpozo9536 3 месяца назад

Very helpful! Thank you

@RoofingIntelligence 3 месяца назад

You're welcome!

@RUBENBUILDINGANDCONSTRUCTION 28 дней назад

❤

@davidholmes7215 Год назад

How many three tab shingles i need for 14x68 foot trailer it has a peak too

@joetrudellmajesticrhythms7269 Год назад

On the triangle section you said 1/2 Rise over Run.. but did 1/2 Run over Rise.. do you always just Half the largest whether you label it zrise and Run ?

@jordanmanntz692 9 месяцев назад

Shorter answer: Where the 1/2 applies does not matter. Long answer: The commutative and associative properties of multiplication mean all of the following have the same sum: 1/2(rise * run) 1/2(run * rise) 1/2rise * run 1/2run * rise

@fuelmemma5236 4 месяца назад

what is the ice and water formula?

@slydog7131 2 месяца назад

Probably linear feet needed. These usually come rolls of 72 or 75 feet. So count up the valley lengths as a start, and then if you are going to use some with pip end vent flashings, add in some for those.